Filter
Top Products
Detailed playback features and additional functions are described in the
accompanying owner’s manual
You should find the below accessories in the packaging box.
Make sure your DVD system and TV are connected and turned on!
Plug & Play
1 Turn on the system.
“AUTO INSTALL PRESS PLAY” will be displayed.
2 Press PLAY 2; on the system to start installation.
Playing a disc
3 Press DISC on the remote control.
You can also select the DISC on the front panel.
4 Turn on the TV and select the correct Video mode.
You should see the blue Philips DVD background screen on the TV (If no disc in the DVD system).
5 Press OPEN
0
CLOSE on the front of the DVD system and load discs, then press the
corresponding OPEN
0
CLOSE again to close the disc tray.
Make sure the disc label is facing up. For double-sided discs, load the side you want to play face up.
6 Playback will start automatically.
If a disc menu appears, use
1/¡/5/4 buttons on the remote control to make the necessary
selection, then press OK to confirm. Or use the numeric keypad on the remote control to
select features. Follow the instructions given in the disc menu.
7 To stop playback, press STOP 9.
Region Codes
DVDs must be labeled for ALL regions or Region 3 ,
in order to play on this DVD system.
3
VNAI
3
Audio cable
( white , red )
MW loop
antenna
FM an
FM an
tenna
enna
Remote control and
AAA sise batteries
Composite vide
cable ( yellow )
Component vide cable
red , blue , green )
(
DIN OUT cable
DIN OUT cable
AC Power cable
AC Power cable
(2 pieces)
(2 pieces)