Filter
Top Products
45
English
WARNING
Under no circumstances should you try to repair the system yourself, as this will invalidate the
warranty. Do not open the system as there is a risk of electric shock.
If a fault occurs, first check the points listed below before taking the system for repair. If you
are unable to remedy a problem by following these hints, consult your dealer or service center.
Problem Solution
No power. – Check if the AC power cord is properly
connected.
“UNREADBLE DISC” is displayed. – Check if the disc is inserted upside down.
–Wait until the moisture condensed at the lens
has cleared.
– Replace or clean the disc, see “Maintenance”.
– Use a readable disc or correctly recorded format
MP3-CD.
No picture. – Select the appropriate video input mode on the
TV set.
– Check if the TV set is switched on.
– Check the video connection.
– Check if the system is securely connected.
Distorted or poor picture. – Sometimes a slight picture distortion may appear.
This is not a malfunction.
– Clean the disc.
– Connect the system to the S-video input of your
TV set.
The aspect ratio of the screen – The aspect ratio is fixed on the DVD disc.
cannot be changed even though – The aspect ratio may not be changed for some
you have set the TV shape. TV systems.
The DVD player does not – Insert a readable disc.
start playback. – Check the disc type, color system and region
code.
– Clean the disc.
– Place the disc with the playback side down.
– Press SYSTEM MENU to turn off the setup
menu.
– Cancel the parental control rating function or
change the rating level.
– Moisture has condensed inside the system.
Remove the disc and leave the system turned on
for about an hour.
The system does not respond – Disconnect the power plug from the jack, and
when the buttons are pressed. insert again.
The language for the sound or – Multi-language sound or subtitle is not recorded
subtitle cannot be changed when on the DVD.
playing a DVD. – Changing the language for the sound or subtitle is
prohibited on the DVD.
No image is output when a – Make sure the component is connected correctly.
function is selected. – Press the correct function button for the input
source.
Troubleshooting