Filter
Top Products
12 EN
8 Product
specifications
Note
• Specicationsanddesignaresubjecttochange
without notice.
Amplier
• Total output power: 60W RMS (30% THD)
• Frequency response: 20 Hz-20 kHz / ±3 dB
• Signal-to-noise ratio: > 65 dB (CCIR) /
(A-weighted)
• Input sensitivity:
• AUX: 600 mV
• Music iLink: 250 mV
Audio
• S/PDIF Digital audio input:
• Coaxial: IEC 60958-3
• Optical: TOSLINK
Main unit
• Power supply: 110-240 V~, 50-60 Hz
• Power consumption: 20 W
• Standbypowerconsumption:≤0.5W
• Speaker impedance: 4 ohm woofer, 4 ohm
tweeter
• Speaker drivers: 25 x 120 mm (1 x 5")
woofer, 38 mm (1.5") tweeter
• Frequency response: 150 Hz-20 kHz
• Dimensions (WxHxD): 708 x 47 x 65 mm
• Weight: 1.03 kg
Subwoofer
• Impedance: 8 ohm
• Speaker drivers: 130 mm (5.25") woofer
• Frequency response: 20 Hz-150 Hz
• Dimensions (WxHxD): 165 x 240 x 295 mm
• Weight: 2.6 kg
• Cable length: 3 m
Remote control batteries
• 1 x CR2025
9 Troubleshooting
Warning
• Risk of electric shock. Never remove the casing
of the product.
To keep the warranty valid, never try to repair the
product yourself.
If you have problems using this product, check the
following points before you request service. If you
still have a problem, get support at www.philips.
com/support.
Main unit
SURR on the front panel blinks continuously.
• Your SoundBar does not support Dolby or
DTS encoded audio. Make sure that you
change the audio output of the TV or device
to 'Standard' or 'PCM'.
Sound
No sound from SoundBar speakers.
• Make sure your TV or other devices’ output is
set to PCM (see 'Connect audio from TV and
other devices' on page 8).
• Connect the correct audio cable from your
SoundBar to your TV or other devices.
• On your SoundBar remote control, press the
Source buttons to select the correct audio
input.
• Make sure that the SoundBar is not muted.
Press VOL +/- to restore the sound (see
'Adjust the volume' on page 10).
Distorted sound or echo.
• If you play audio from the TV through the
SoundBar, make sure that the TV is muted.