Philips CDR 786 CD Player User Manual


 
For playback on the CD recorder from the CD changer deck the
following outputs are present:
– Digital coaxial output (CD & CD-R)
– Analog output (CD & CD-R)
We advise you to connect these to the TAPE or CD-R input on
your amplifier.
For external recording the following inputs are present:
– Digital optical input
– Digital coaxial input
– Analog input (stereo)
The connections you make will depend upon the possibilities
your audio equipment offers. Please refer to the user manuals
for your other audio equipment first.
Digital recordings (optical or coaxial) give the best
performance in audio and usability (e.g. auto-track).
(The digital optical connection is less sensitive to external
disturbances).
If your equipment does not offer digital connections, the high
quality Analog-Digital-Convertor of your set will ensure very
good audio performance when recordings are made from the
analog input.
Playback via the digital coaxial output of the CD recorder
gives the best audio performance.
If your equipment does not offer digital connections, the high
quality Digital-Analog-Convertor of the set ensures a very
good sound quality via the analog output.
We advise you to always establish both digital and analog
connections. In this way you can always make analog
recordings when digital recording is not possible.
We have described the most common ways of connecting the
CD recorder. If you still have difficulties with the connections
you can always contact the Philips Consumer Service desk in
your country.
This connection must be made for playback on the CD
recorder deck as well as the CD changer deck (cable 2).
Cable 1 is only required if you want to make recordings from
an external analog source.
Use the audio cables supplied. Connect the red plugs to the
R sockets, and the white plugs to the L sockets.
1 For external recording, connect cable 1 between the
ANALOG IN-sockets on the set and the CDR LINE- or TAPE
OUT-sockets of an amplifier.
Note: For recording directly from a CD player or tape deck,
the analog input of the set should be connected to the
analog output of the CD player or tape deck.
2 For playback, connect cable 2 between the ANALOG OUT-
sockets on the set and the input sockets of an amplifier e.g.
TAPE IN, CD-R or AUX.
Note: Never use the PHONO input.
ANALOG
DIGITAL
IN OUT
IN OUT
OPTICAL
IN
L
R
TAPE/CDR
IN OUT
L
R
L
R
RECEIVER/AMPLIFIER
CD RECORDER
1
2
Analog connectionsConnections general
INSTALLATION
12
English
xp CDR785/00 engels.4 14-11-2000 16:30 Pagina 12