Philips C70 Stereo Receiver User Manual


 
3139 116 19441 (ENG)
22
TIMER SLEEP TIMER
To exit without storing the setting,
press Ç on the system.
Notes:
During clock setting, if no button is
pressed within 90 seconds, the system
will exit clock setting mode
automatically.
When a power interruption occurs, the
clock setting is erased.
Timer Setting
The system can switch on to CD or
TUNER mode automatically at a
preset time. It can serve as an alarm
to wake you up.
Before setting the timer, make sure
the clock is set correctly.
The timer will always be switched on
once it is set.
The volume of the timer will
increase from the minimum
level to the most recently
selected volume level.
1 Press and hold CLOCK/TIMER for
more than two seconds to select
timer mode.
AM 12:00” or “00:00" or
the last timer setting starts flashing
depending on whether you have
selected 12- or 24-hour mode..
The TIMER starts flashing.
The selected source is lit while
other available sources are
flashing.
2 Press CD or TUNER to select the
desired source.
Before selecting CD, make sure a CD
is loaded in the CD carousel tray.
3 Press␣ à or á on the system to set
the hour for the timer to start.
4 Press␣ í or ë on the system to set
the minute for the timer to start.
5 Press CLOCK/TIMER to store the
start time.
The timer is now set.
The TIMER remains on the display.
At the preset time, the timer will be
activated.
The selected source will be
played.
Notes:
During timer setting, if no button is
pressed within 90 seconds, the system
will exit timer setting mode
automatically.
If the source selected is TUNER, the
last tuned frequency will be switched
on.
If the source selected is CD, playback
will begin with the first track of the
selected disc or program. If the CD
trays are empty, TUNER will be
selected instead (not for all versions).
The timer will not activate if a recording
is in progress.
To switch off the TIMER
1 Press and hold CLOCK/TIMER for
more than two seconds.
2 Press Ç on the system to cancel the
timer.
The timer is now switched off.
The display will show "OFF" and
the TIMER disappears.
To start the TIMER again (for the
same preset time and source)
1 Press and hold CLOCK/TIMER for
more than two seconds.
2 Press CLOCK/TIMER again to
store the start time.
The timer is now on.
The TIMER appears on the display.
Sleep Timer (only on remote
control)
This feature allows you to select a
length of time after which the system
will switch to the standby mode
automatically.
1 Press SLEEP TIMER on the
remote control repeatedly to select a
period of time.
The selections are as follows (time
in minutes):
60 45 30 15 OFF
60
SLEEP XX” or “OFF” will be
displayed. "XX" is the time in
minutes.
2 When you reach the desired length
of time, stop pressing the SLEEP
TIMER button.
After this amount of time passes,
the system will switch to the
standby mode.
To switch off the Sleep Timer
Press SLEEP TIMER repeatedly
until "OFF" is displayed, or press the
STANDBY ON button.
pg 01-28/C50-C70/37-Eng 18/11/1999, 2:39 PM22