Filter
Top Products
TUNING
Direct Access tuning
The frequency of the station you wish to tune to must be
known. You can find these frequencies in station tables or
radio guides.
1
In the radio mode, press ENTER.
™ The current frequency in the display disappears.
2
Use the Preset memory buttons to enter the digits of your
desired frequency within a 5 second period.
3
Press ENTER again to confirm your radio station.
™ The display shows the selected frequency or the nearest
frequency.
™ If you have made an incorrect entry, Errwill appear in
the display.
Entry examples of bands and frequencies:
e.g.i 98.1 MHz, FM: Press 9,8,1 and ENTER
e.g.ii 603 KHz, AM (MW): Press 6,0,3 and ENTER
Manual tuning
•
Press TUNING – or + briefly, once or as often as required
until the right frequency is found. In this way, the frequency
can be changed step by step.
Automatic tuning
1
Press and hold down the TUNING – or + control until the
display frequency starts to run.
2
When a station of sufficient strength has been found, tuning
will stop, or you can stop the automatic tuning by pressing
the TUNING – or + control again.
3
Repeat until you have found the desired station.
SELECTING & STORING FREQUENCIES: PRESETS
You can store the frequencies of 20 radio stations in the
memory, 10 on each waveband. A stored frequency is only
erased from the memory by storing another frequency in its
place, or if you reset your unit.
1
Select the waveband and tune to your desired station.
2
Select and press one of the Preset memory buttons 0-9 for
more than two seconds to store your station.
™
PRESET and your selected number will appear in the display.
7
AQ 6688 /00 - page 7
RADIO RECEPTION
English