Filter
Top Products
1.
2.
1. Nail or screw bracket to
joists.
2. Finish installing ceiling.
8. Remove paint mask
unless painting is required.
In that case, follow steps
9-12 when painting is
complete.
10. Attach grille safety clip
by placing the large end of
the clip over snap-fit post (1),
then sliding clip until small
end snaps into place around
post (2).
3. Use RotoZip or other tool
to cut hole.
6. If required, attach
seismic restraint system to
the sheet-metal tab on the
rear panel of the speaker,
then to reinforced structure
(safety cable not included).
11. Align tabs on snap-fit
grille with slots in baffle,
gently press grille into place.
4. Unpack speaker. Leave
paint mask in place until
after speaker is installed or
painting is complete.
12. Done!
T E C H N O L O G Y
Installation Instructions: Installing the CI-1.5
Using Optional Pre-Construction Bracket
R
9. Adjust tap switch to
proper setting. Switch is
preset to the 8-ohm mode.
5. Connect euroblock to
speaker wires, and connect
to speakers.
7. Insert speaker into
mounting hole. Tighten both
screws on the baffle face to
actuate the mounting wings.
DO NOT OVERTIGHTEN.