Filter
Top Products
28. EFX DEFEAT: This 1/4" jack accepts an on/off 1/4" footswitch (Peavey Pt. #00051000) to defeat the
effects of both the Main and Monitor mixes.
29. MONITOR OUTPUT: This 1/4" jack provides an output from the monitor mix to supply external power
amp/monitor combinations. The level of this signal is determined by the Monitor Level control.
30. LEFT/MONO OUTPUT: This 1/4" jack provides an output from the Left Main mix to supply external
amp/speaker combinations. The level of this signal is determined by the Main Level control. When no
plug is connected to the Right Output (#31) then the right signal is mixed with the left, and both can
be accessed at the Left/Mono Output. This works well when you use the internal amps for monitor and
external amps for Main. Only one patch cord is required to get the Main out to the external amp. In
order to utilize both internal amps for Monitors then patch from Monitor Out into Right Power input.
31. RIGHT OUTPUT: This 1/4" jack provides an output from the Right Main mix to supply external
amp/speaker combinations. The level of this signal is determined by the Main Level control.
32. POWER AMP INPUTS: Plugging into these jacks allows the user to go directly into the graphic
equalizer, then into its respective power amplifier channel, and therefore bypass the other functions of
the XR
®
696.
33. POWER LED: The power “on” LED indicator will light when the unit is powered.
AC POWER AND POWER AMPLIFIER SECTION:
34. A/C POWER INLET: This is the receptacle for an IEC line cord,
which provides AC power to the mixer/amplifier. Connect the line
cord to this connector to provide power to the unit. Damage to
the equipment may result if improper line voltage is used (see
line voltage marking on unit).
35. POWER: The XR 696’s main power switch. The power on LED
indicator (#33) will light when the unit is powered.
36. FUSE: This is the main safety fuse for the AC line voltage. Only
replace the fuse with one the exact same type and rating. IF THE FUSE CONTINUES TO OPEN, DO
NOT OVER FUSE. TAKE THE UNIT TO AN AUTHORIZED PEAVEY SERVICE CENTER!
37. PARALLEL LEFT/RIGHT SPEAKER OUTPUTS: These 1/4" jacks are the amplifier’s outputs. By
connecting a speaker cable to this jack and to a speaker cabinet, you complete the signal chain.
You will notice that there are two pairs of jacks. The two pairs are your two (stereo) amp outputs.
Two cabinets can be connected to each channel, as long as the combined impedance of the cabinets
is not less than 4 Ohms. (i.e., two 8 Ohm cabinets in parallel = 4 Ohms, four 16 Ohm speakers in
parallel = 4 Ohms, etc.).
8
POWER
500 WATTS
60 Hz
120 VAC
OFF
ON
FUSE
15 AMP
34 36
35
37
CLASS 2 WIRING
RIGHT/MAIN
4
MIN
OHM
LEFT/ MONITOR
4
MIN
OHM