Peavey Penta Tube Amplifier Stereo Amplifier User Manual


 
10
Rear Panel-Domestic
Footswitch (12)
This 1/4" mono jack is provided for use with a single-button footswitch. This creates the capability to
switch from the Pentatone™ setting on the front to the setting on the back. Without the footswitch,
only the front Pentatone setting will function.
Pentatone (13)
This switch allows the user to select one of the five standard settings in conjunction with the footswitch.
Speaker Outputs (14)
These 1/4" mono jacks provide two connections for speaker cabinets.
Impedance Selector (15)
This switch must be set properly depending upon the speaker cabinet used. If two 16 ohm cabinets are
being used the switch should be set to 8 ohm.
Ground (16)
This three-position switch is used when you have a hum problem. Try using this switch to eliminate hum
problems that are related to the AC mains or AC line grounding.
Line Cord (120 V units only) (17)
For your safety, we have incorporated a three-wire line (mains) cable with proper grounding facilities. It
is not advisable to remove the ground pin under any circumstances. If it is necessary to use the Penta
without proper grounding facilities, suitable grounding adapters should be used. Greatly reduced shock
hazard exists when the unit is operated with the proper grounded receptacles.
Fuse (18)
A 6A/250
amp fuse is located within the cap of the fuseholder. It must be replaced with the same type
and value in order to avoid damage to the equipment and to prevent voiding the warranty. If the amp
repeatedly blows fuses, it should be taken to a qualified service center for repair.
WARNING: The fuse should only be replaced when the power cord has been disconnected from
its power source.
12
13
14
15
16
17 18