Filter
Top Products
6
((77)) LLOOOOPP--TTHHRRUU JJAACCKKSS
Loop Out takes the signal after the balanced inputs and the volume control and allows one to send this signal to
another Impulse
®
100P via its Loop In Jack.
These are unbalanced high Z jacks, so do not run the cable very far.
OOPPEERRAATTIINNGG IINNSSTTRRUUCCTTIIOONNSS
CCAAUUTTIIOONNSS
The unit must be disconnected from the AC power source before any work is done on it. Refer all servicing to
qualified service personnel.
The heat sink on the back plate can become hot to the touch. Do not block or cover the heat sink from ventilation.
Be sure to keep the microphone away from the front of the speaker after switching the mic input on, and during
level setting of the microphone, or very loud feedback will occur! Damage to the system is likely if this occurs!
DO NOT connect the inputs of the Impulse 100P to the output of a power amplifier; the inputs are meant to be
driven from a line-level strength signal.
DO NOT remove the protective metal grille.
DO NOT use the INPUTS/OUTPUTS jacks as mixers by trying to run more than one signal source at a time into
them. The INPUTS/OUTPUTS jacks (5) are all hard-wired together to allow use of any of the connector types as an
input, and to allow a further send or “daisy-chaining” of the input signal to some other audio device (such as
another Impulse 100P). Attempting to run two different signals directly into the Impulse 100P could damage the
outputs of the source units. Use a mixer to combine two or more signals into a single signal sent to the Impulse
100P input.
WWAARRNNIINNGG::
The Impulse 100P is extremely efficient and powerful! This sound system can permanently damage
hearing! Use extreme care setting the overall maximum loudness!
The apparent sound level of the Impulse 100P can be deceiving due to its clear, clean sound output. The lack of
distortion or obvious distress can make the sound level seem much lower than it actually is. This system is
capable of SPLs in excess of 120 dB at 1 M from the speaker!
UUSSEE OOFF TTHHEE IIMMPPUULLSSEE 110000PP
FFLLYYIINNGG TTHHEE IIMMPPUULLSSEE 110000PP
CCaauuttiioonn::
The suspending or flying of the Impulse 100P must be done by a certified structural engineer.
Important Safety Information for the Mounting Peavey Impulse 100P speaker systems.
CCaauuttiioonn::
Before attempting to suspend these speaker models, consult a certified structural engineer. Speaker
can fall from improper suspension, resulting in serious injury and property damage. Other enclosures may not be
suspended below one, nor should additional weight be suspended from one of these units. Use only the correct
mating hardware. All associated rigging is the responsibility of others.