Filter
Top Products
THE
Sl
OUTPUT
MODULE REAR VIEW
LOW CURRENT
STEREO MODE (18)
(Option
1)
This
Sl
module is shipped
wired as follows: lt as the
channel signal output and 1
as the channel chassis
ground. This is really the
defacto standard for most
low-to-medium power
loudspeaker systems. This
wiring allows one enclosure
to be connected to channel
A, and one enclosure to be
connected to channel
B.
The
2 t and 2
-
connections are
simply not used in this
application! In this case the
2 t and the 2
-
spades are
used to “store” the jumper
cables for later usage.
THE Sl OUTPUT
MODULE REAR,VIEW
HIGH CURRENT
STEREO MODE (19)
(Option 2)
Many larger loudspeaker
systems use the full
capability of the
SPEAKON
connector by paralleling 1 t
and
2t,
and paralleling 1
-
and 2
-.
This wiring improves
the current handling
capability of the system and
reduces losses. Most “subs”
with
SPEAKONs
are wired
this way. This module can be
easily re-wired to this
configuration using the
supplied jumpers on the rear
of the module. Normally four
jumpers are plugged in a
no-
connect configuration for
“storing”. In this case, one
jumper is connected
between 1 t and
2t
and
another jumper is connected
between 1
-
and 2
-
for each
channel. This is a total of
four jumpers. The diagram (19) shows the wiring of the jumpers.
THE Sl OUTPUT MODULE REAR VIEW
-
BRIDGE MODE (20) (Option 3)
This module can be re-wired to allow the
SPEAKONs
to be the bridge outputs with both in parallel. This arrangement would allow for
example, two 8 ohm enclosures to be connected in parallel to the
CS
800s in bridge mode. In this case the wiring is as
follows:lt
on
both connectors wired to channel A signal output; 1
-
on both connectors wired to channel B signal output;
2t
and 2
-
on both