Peavey CC 1800 Stereo Amplifier User Manual


 
p. 16
a
specifications
CC
TM
Series
4000
Rated Power Bridge 4 ohms
4,000 watts @ 1 kHz at <0.1% T.H.D.
Rated Power (2 x 2 ohms)
2,000 watts per channel @ 1 kHz <0.1% T.H.D. both channels driven
Rated Power (2 x 4 ohms)
1,350 watts per channel @ 1 kHz at <0.05% T.H.D. both channels driven
Rated Power (2 x 8 ohms)
800 watts per channel @ 1 kHz at <0.05% T.H.D. both channels driven
Rated Power (1 x 2 ohms)
2,550 watts @ 1 kHz at <0.1% T.H.D.
Rated Power (1 x 4 ohms)
1,600 watts @ 1 kHz at <0.05% T.H.D.
Rated Power (1 x 8 ohms)
900 watts @ 1 kHz at <0.05% T.H.D.
Minimum Load Impedance
2 ohms
Maximum RMS Voltage Swing
93 volts
Frequency Response
10 Hz - 100 kHz; +0, -2 dB at 1 watt
Power Bandwidth
10 Hz - 35 kHz; +0, -3 dB at rated 4 ohm power
T.H.D. (2 x 2 ohms)
<0.2% @ 1,475 watts per channel from 20 Hz to 20 kHz
T.H.D. (2 x 4 ohms)
<0.1% @ 1,150 watts per channel from 20 Hz to 20 kHz
T.H.D. (2 x 8 ohms)
<0.1% @ 700 watts per channel from 20 Hz to 20 kHz
Input CMRR
> -65 dB @ 1 kHz
Voltage Gain
x40 (32 dB) x20 (26 dB)
Crosstalk
> -65 dB @ 1 kHz at rated power @ 8 ohms
Hum and Noise
> -112 dB, “A” weighted referenced to rated power @ 8 ohms
Slew Rate
> 15V/us
Damping Factor (8 ohms)
> 500:1 @ 20 Hz - 1 kHz
Phase Response
+5 to - 15 degrees from 20 Hz to 20 kHz
Input Sensitivity (x40)
1.88 volts +/- 3% for 1 kHz, 4 ohm rated power, 1.62 volts +/- 3% for 1 kHz, 2 ohm rated
power
Input Impedance
15 k ohms, balanced
Current Draw @ 1/8 power
1,825 watts @ 2 ohms, 1,185 watts @ 4 ohms, 720 @ 8 ohms
Current Draw @ 1/3 power
4,535 watts @ 2 ohms, 2,975 watts @ 4 ohms, 1,835 watts @ 8 ohms
Cooling
Two back panel temperature dependant variable speed 80 mm DC fans
Controls
2 front panel attenuators, rear panel Mode switches
Indicator LEDs
2 ACL™ (automatic clip limiting), 2 Signal presence, 2 Active status, 2 Temp
Protection
Thermal, DC, turn-on bursts, subsonic, incorrect loads
Connectors
Combi XLR & 6.3 mm phone input, Speakon and 5-way Binding Post speaker output, 15
amp IEC mains connector
Construction
16 ga. steel with cast front panel and cast handles
Dimensions
88.9 mm x 482.6 mm x 377.8 mm + 31.8 mm for rear support ears and connectors
(3.5" x 19" x 14.875" + 1.25")
Net Weight
19.64 kg (43.3 lbs.)
Gross Weight
20.8 kg.(45.8 lbs.)
All power measurements made at 120 VAC, power transformer cold. 2 ohm power is time limited by magnetic circuit breaker.
CC
TM
owner’s manual