Filter
Top Products
11
Selecting this button takes you to the preset configuration page.
The VSX™ is pre-programmed with eight configuration templates
representing the most frequently used crossover possibilities. As you
scroll through the configuration presets you will see and can adjust
the basic filter types (only symmetrical choices may be made here).
Center frequencies of those filters and a graphic representation
of the filters will be displayed. You must enter “OK” to accept the
selection. Selecting and pressing Exit or pressing the Setup button
will return you to the main screen. Upon returning to the main screen
you will see the graphic representation of your selection.
Output levels may be adjusted on this page. Press “done” or push
the setup button to return to the main screen.
Inputs A & B or outputs 1-6 should be selected on the top of the
screen. While on the top of the screen push the data wheel and an
arrow appears. Rotate the wheel to select which input or output you
wish to adjust.
on inputs
This switch gives a paragraphic action to the 27 band equalizer. It toggles between 1/6, 1/3, 1/2 and 1
octave bandwidth for the width of the individual filters. Bandwidth is defined 3 dB from the peak or minimum
amplitude and greatly affects the way the adjacent filters combine or stay independent. Wider bandwidth is
most useful when adjusting the overall curve of the speaker to the room or tone control as ripple is minimized.
The 1/6
th
bandwidth has the least filter skirt combining and should be used for feedback control only.
As you scroll through the 27 positions the knob graphic becomes filled and the corresponding frequency is
listed on the bottom left. Press the data wheel to select a frequency to adjust.
After selecting a frequency, rotating the data wheel allows boosting or cutting the amplitude of the selected
frequency +/- 15 dB in .5 dB increments.
Pressing the EQ button is a short cut to return to the top of the screen.