Filter
Top Products
5
SR-1 Owner’s Manual
Caution: These boxes are heavy and require two people using
proper lifting techinques and care when unpacking.
Your SR-1 system comes double boxed with each cabinet in it’s
own double box. Within the double box, each speaker sits in rigid
foam top and bottom trays. We do not suggest that you attempt to
separate inner and outer boxes.
Starting with the two large boxes: Carefully cut the tape securing the
top end-flap on the outer box. Repeat for the inner box. If you
have done this correctly you will now be looking at the bottom of
the speaker, the lower foam tray and a box of hardware containing 4
feet and a jumper cable. Remove and retain the foam tray for future
use.
Once the bottom tray is removed, install the four leveling feet with
the protective washers between the feet and cabinet. The “no-mar”
washers are essential to protect the wood surfaces of the cabinet
from the anodized surface of the leveling feet.
Once the feet are installed, unpack the large (bass) cabinet by tilting
the packing on it’s side first and then titling so the bass cabinet is
resting on it’s feet. At this time lift the outer and inner boxes straight
up and off of the speaker. Retain these boxes as storage containers
for all additional SR-1 packing materials. Remove and retain the
top tray and foam sock. Now place the bass cabinet aas close to the
intended and final location. Once the smaller top cabinet is in place
further movement other than minor positional changes of the large
cabinet will not be convenient.
The top cabinet will be unpacked in a similar fashion. Carefully cut
the tape securing the tops of the outer and inner boxes. Once the
boxes are open you should again be viewing the bottom surface of
the cabinet and a box of hardware.
The smaller top cabinets require that the user install several pieces of
adjustment and dress hardware. All of these pieces will be installed
Unpacking