Filter
Top Products
10
RQTX0234
Quick Start Guide
Getting Started
Conserving power
The main unit and the wireless system consume a small amount of
power when they are turned off (main unit: approx. 0.2 W, wireless
system: approx. 0.3 W). To save power when they are not to be used for
a long time, unplug them from the household mains socket.
You will need to reset some memory items after plugging in the main
unit.
[Note]
The included AC mains leads are for use with the main unit and wireless
system only. Do not use them with other equipment. Also, do not use
leads for other equipment with the main unit or wireless system.
Turn on the wireless system after all connections are complete.
Do not:
≥mix old and new batteries.
≥use different types of batteries at the same time.
≥take apart or short circuit.
≥attempt to recharge alkaline or manganese batteries.
≥use batteries if the covering has been peeled off.
Mishandling of batteries can cause electrolyte leakage which can
severely damage the remote control.
Remove the batteries if the remote control is not going to be used for a
long period of time. Store in a cool, dark place.
Aim at the remote control signal sensor (B 39), avoiding obstacles, at a
maximum range of 7 m directly in front of the unit.
step 4 AC mains lead connection
AC IN
AC IN
110
127V 220
240V
VOLT ADJ
Use a flat-head screwdriver to move the voltage
selector to the appropriate position for the area
in which this system is used.
Except [Australia]and[N.Z.]
Before connecting the AC mains lead
Set the voltage.
To household
mains socket
Main unitWireless system
AC mains lead
(included)
Ferrite core
AC mains lead
(included)
To
household
mains
socket
step 5 Preparing the wireless system
step 6 Preparing the remote control
WIRELESS LINK
WIRELESS LINK indicator
Red: The wireless system is on and the wireless link is deactivated.
Green: The wireless system is on and the wireless link is activated.
(“ [W1] ” is also displayed on the main unit’s display.)
Press [C I, BÍ] on the wireless system.
Unit on/off button [C I, BÍ]
Use this button to turn the wireless system on and off.
C I: The wireless system is on.
BÍ: The wireless system is off.
Wireless system
Batteries
CAUTION
Danger of explosion if battery is incorrectly replaced. Replace only
with the same or equivalent type recommended by the manufacturer.
Dispose of used batteries according to the manufacturer’s instructions.
≥Use alkaline or manganese batteries.
≥Do not heat or expose to flame.
≥Do not leave the battery(ies) in an automobile exposed to direct
sunlight for a long period of time with doors and windows closed.
R6/LR6, AA
Insert so the poles (i and j) match those in the remote control.
Press in and lift up.
Replace the cover.
Use
RQTX0234-B_eng.book Page 10 Thursday, February 5, 2009 10:42 AM