Filter
Top Products
RQTV0160
9
FM/AM Radio
Manual tuningManual tuning
1
Press [TUNER/BAND] to select “FM” or “AM”.
2
Press [PLAY MODE] to select “MANUAL”.
3
Press [ /4] or [ /¢] to select the frequency of
the required station.
“
ST ”
is displayed when a stereo FM broadcast is being
received.
To tune automatically
Press
[ /4] or [ /¢] for a moment until the frequency
starts changing rapidly. The unit begins auto tuning, stopping
when it fi nds a station.
• Auto tuning may not function when there is excessive
interference.
• To cancel auto tuning, press [ /4] or [ /¢] once
again.
To improve FM sound qualityTo improve FM sound quality
Press and hold [PLAY MODE] to display “MONO”.
To cancel
Press and hold [PLAY MODE] again until “MONO”
disappears.
• MONO is also canceled if the frequency is changed.
• Turn off “MONO” for normal listening.
Memory presetMemory preset
Up to 15 stations can be set in both the FM and AM bands.
Preparation
Press [TUNER/BAND] to select “FM” or “AM”.
Automatic presettingAutomatic presetting
Press and hold [PROGRAM] to start presetting.
Manual presettingManual presetting
1
Press [PLAY MODE] to select “MANUAL”.
2
Press [ /4] or [ /¢] to tune to the required
station.
3
Press [PROGRAM].
4
Press the numeric buttons to select a channel.
The station occupying a channel is erased if another
station is preset in that channel.
5
Repeat steps 2 to 4 to preset more stations.
Selecting a preset stationSelecting a preset station
Press the numeric buttons to select the channel.
For channels 10 to 15 press [
h
10], then the two digits.
OR
1
Press [PLAY MODE] to select “PRESET”.
2
Press [ /4] or [ /¢] to select the channel.
FM allocation settingFM allocation setting
By main unit only
This system can also receive FM broadcasts allocated in
0.1 MHz steps.
To change the step to 0.1 MHz
1
Press [TUNER/BAND] to select “FM”.
2
Press and hold [TUNER/BAND].
After a few seconds the display changes to a fl ashing
display of the current minimum frequency.
3
Continue to hold down [TUNER/BAND].
•
When the minimum frequency changes, release the button.
To return to the original step, repeat the above steps.
•
After the setting is changed, any previously preset
frequency will be cleared.
Numeric
buttons
PM321_P-En.indd 9PM321_P-En.indd 9 7/13/06 11:42:36 AM7/13/06 11:42:36 AM