Filter
Top Products
29
RQT7991
Other speaker setup options
Other speaker setup options
∫ Attaching to a wall
You can attach all of the speakers to a wall.
1 Drive a screw (not included) into the wall.
2 Fit the speaker securely onto the screw(s) with the hole(s).
≥The wall or pillar on which the speakers are to be attached should be capable of supporting 10 kg per screw. Consult a qualified building
contractor when attaching the speakers to a wall. Improper attachment may result in damage to the wall and speakers.
≥When mounting the front or surround speakers to a wall, we recommend using a string (not included) to prevent it from falling (➜ page 4).
≥Use of optional speaker cables is recommended for wall-mounted front or surround speakers. (You can also remove the speaker cables from the
pipes supplied with this system).
∫ Fitting speaker stands (not included)
(Center speaker only)
Ensure the stands meet these conditions before purchasing them.
Note the diameter and length of the screws and the distance between screws as shown in the diagram.
≥The stands must be able to support over 10 kg.
≥The stands must be stable even if the speakers are in a high position.
30–35 mm
‰7.5–9.4 mm
4.0–7.0 mm
Wall or pillar
‰3.0–4.0 mm
180 mm
In this position, the
speaker will likely
fall if moved to the
left or right.
Move the speaker
so that the screw is
in this position.
Center speaker
Front and surround speakers
366 mm
175 mm
Speaker stand
(not included)
Plate thickness plus
7mm to 10mm
Attach the stands to
these metal screw
holes.
60 mm
5 mm, pitch 0.8 mm
HT880W_En.book Page 29 Wednesday, February 2, 2005 6:27 PM