Filter
Top Products
15
RQT9882
ENGLISH
Static or noisy reception is heard while
listening to a radio broadcast.
≥ Confirm the FM antenna is properly connected. (l p. 6)
≥ Adjust the position of the antenna.
≥ Try to keep a certain amount of distance between the
antenna and AC power supply cord.
≥ Try using an external antenna if there are buildings or
mountains nearby. (l p. 6)
≥ Turn the TV or other audio players off or separate it from
this unit.
≥ Keep this unit away from cell phones if there is
interference.
Stations cannot be selected.
Change the FM frequency step.
1 Press [RADIO/AUX] to select “FM”.
2 Press and hold [SELECTOR] on the unit.
After a few seconds the display changes to show the
current lowest frequency. Continue to hold the button
down. The lowest frequency changes and the step is
changed.
The remote control does not work properly.
≥ The battery is depleted or inserted incorrectly. (l p. 5)
The following messages or service numbers
may appear on the unit’s display.
“--:--”
≥ You plugged the AC power supply cord in for the first
time or there was a power failure recently. Set the time
(l p. 12).
“ADJUST CLOCK”
≥ Clock is not set. Adjust the clock accordingly.
“ADJUST TIMER”
≥ Play timer is not set. Adjust the play timer accordingly.
“AUTO OFF”
≥ The unit has been left unused for about 20 minutes and
will shut down within a minute. Press any button to
cancel it.
“DIMMER”
≥ Appears 10 seconds after the volume is turned to “0”.
“ERROR”
≥ Incorrect operation is performed. Read the instructions
and try again.
“F ” (“ ” stands for a number.)
≥ There is a problem with this unit.
Write down the displayed number, disconnect the AC
power supply cord and consult your dealer.
“ILLEGAL OPEN”
≥ Sliding door is in the wrong position. Turn the unit off and
on again. If this display appears again, consult the
dealer.
“NO DISC”
≥ Insert a disc to be played. (l p. 7)
“NO PLAY”
≥ A CD that is not in CD-DA format is inserted. It cannot be
played.
≥ The unit may have a problem. Turn the unit off and then
on again.
“READING”
≥ The unit is checking the CD information. After this
display has disappeared, start operating.
“REMOTE ” (“ ” stands for a number.)
≥ The remote control and this unit are using different
codes. Change the code on the remote control.
– When “REMOTE 1” is displayed, press and hold [OK]
and [ ] for at least 4 seconds.
– When “REMOTE 2” is displayed, press and hold [OK]
and [CD] for at least 4 seconds.
Radio
Remote control
Messages
SC-HC39_PPC~body1_mst.fm 15 ページ ２０１４年２月６日 木曜日 午後７時１８分