Filter
Top Products
4
RQT9742
Control reference guide
1 Standby/on switch [Í/I] (Í)
Press to switch the unit from on to standby mode or
vice versa.
In standby mode, the unit is still consuming a small
amount of power.
2 Select the audio source
On the remote control
[iPod]: “IPOD_DOCK” ,. “IPOD_PORT”
[CD/RADIO]: “CD” ,. “FM”
[]: “BLUETOOTH”
On this unit:
“CD” -. “FM” -. “BLUETOOTH” -. “IPOD_DOCK”
^--------------------- “IPOD_PORT” (----------------b
3 Basic playback control buttons
4 Enter setup menu
5 Enter the iPod
®
/iPhone
®
menu /
Change displayed information
6 Open or close the sliding door
7 Adjust the volume (0 (min) to 50 (max))
8 Mute the sound
Mutes the sound. Press again to cancel.
“MUTE” is also canceled when the volume is adjusted
or the unit is turned off.
9 Enter playback menu
10 Enter sound menu
11 Selection/OK
12 “IPOD_PORT” for iPod/iPhone/iPad
®
(l 6)
13 Dynamic Bass sound effect selector
14 Power on indicator
15 Display
16 Sliding door
17 Remote control signal sensor
Distance:
Within approx. 7 m (23 ft) directly in front.
≥ To avoid interference, please do not put any objects
in front of signal sensor.
Unless otherwise indicated, operations are
described using the remote control.
SELECTOR
iPad
12
13673216
14
15 16
17
CD/
RADIO
Top view
∫ Before using for the first time
Remove the insulation sheet A.
∫ To replace a button-type battery
Battery type: CR2025 (Lithium battery)
≥ Set the button-type battery with its (i) mark
facing upward.
≥ Keep the button-type battery out of reach of
children to prevent swallowing.
SC-HC38~RQT9742.book Page 4 Tuesday, December 11, 2012 2:20 PM