Filter
Top Products
34
VQT5F59
Reference
Troubleshooting guide
Before requesting service, please perform the
following checks.
If the problem remains unresolved, consult
your dealer for instructions.
∫ Unit does not respond to remote
control or unit’s buttons.
Disconnect the AC mains lead, wait 1 minute,
then reconnect the AC mains lead.
The following do not indicate a problem with
this unit:
– Regular disc rotating sounds.
– Image disturbance during search.
– Image disturbance when replacing 3D discs.
∫ Cannot eject disc.
1 Turn the unit on.
2 Press and hold [OK], the yellow button and
the blue button on the remote control at the
same time for more than 5 seconds.
j“00rEt” is displayed on the unit’s display.
3 Press [1] (right) repeatedly on the remote
control until “06FtO” is displayed on the unit’s
display.
4 Press [OK].
To return to the factory defaults.
¾ Select “Yes” in “Default Settings” in the Setup
menu. (> 31)
To return all settings to the factory preset.
¾ Reset the unit as follows:
1 Turn the unit on.
2 Press and hold [OK], the yellow button and
the blue button on the remote control at the
same time for more than 5 seconds.
j“00rEt” is displayed on the unit’s display.
3 Press [1] (right) repeatedly on the remote
control until “08FIn” is displayed on the unit’s
display.
4 Press and hold [OK] for at least 5 seconds.
The remote control does not work properly.
¾ Change the batteries in the remote control.
(> 9)
¾ Depending on the condition of the unit,
[SELECTOR] and [ ] may not respond.
Display the HOME menu and try again.
The TV tuner mode is not displayed when the
TV is turned on.
¾
This phenomenon may occur, depending on the
TV setting, when “Quick Start” is set to “On”.
You have forgotten your ratings password.
You want to cancel the ratings level.
¾ The ratings level returns to the factory
defaults.
1 Turn the unit on.
2 Press and hold [OK], the yellow button and
the blue button on the remote control at the
same time for more than 5 seconds.
j“00rEt” is displayed on the unit’s display.
3 Press [1] (right) repeatedly on the remote
control until “03 VL” is displayed on the unit’s
display.
4 Press [OK].
Do you have the latest firmware installed?
Panasonic is constantly improving the unit’s
firmware to ensure that our customers are
enjoying the latest technology. (> 14)
General operation
SC-BTT465&405&105EB-VQT5F59_mst.book 34 ページ ２０１４年１月２４日 金曜日 午後３時４４分