Filter
Top Products
6
RQT7972
Simple setup
[HT933]
1 Attach the pipe to the base.
1 Thread the speaker cable through the base.
2 Insert the pipe.
3
Secure the pipe to the base.
Ensure the screws are
securely fastened by lightly
tightening the left and right
side screws alternately until
fully tightened. (The heads of
the screws protrude slightly
even if you have fully
tightened them.)
2 Attach the stand to the speakers.
≥
There is no difference between the right and left speakers and stands.
≥Using the polyfoam included with this unit may be convenient.
Ensure the stand is fastened on straight by lightly tightening the top
and bottom screws alternately until fully tightened.
∫ Front speaker height
(Assembled diagram)
3 Adjust the speaker height.
≥Check the screws you tightened in procedures 1 and 2 if the pipe
and speaker are loose.
e.g. Attaching the stand to the lower rear
STEP1
Front speaker assembly
2 Front speakers 2 Bases2 Pipes 4 Small screws4 Large screws
The supplied stands are specially designed for
attachment to Panasonic SB-PF920 front speakers.
Only use as indicated in this setup.
Lessen excess
speaker cable.
Thread the speaker
cable through here.
Cable
Groove
Holes for screws
Insert the pipe while gently
pulling on the speaker cable.
Rear side of base
Cable
Large
screws