Filter
Top Products
Before using
11
RQT6085
A
B
SLEEP
–AUTO OFF
1
2
3
4
CL
CL
OCK/
CK/
TIMER
TIMER
1
3
2 • 4
Auto-off function
Remote control only
When CD or tape is selected as the source
To save power, the unit turns off if it is left unused for ten minutes.
Note
This function does not work if the source is tuner or AUX.
Press and hold [–AUTO OFF].
“AUTO OFF” is shown on the display.
To cancel
Press and hold [–AUTO OFF] again to clear “AUTO OFF” from the
display.
For your reference
The setting is maintained even if the unit is turned off. When the unit is
turned on again, “AUTO OFF” is displayed and the unit functions as
described above.
“AUTO OFF” disappears from the display if either tuner or AUX is
selected as the source but continues to function normally.
“AUTO OFF” remains displayed if CD or tape is selected as the
source.
A
Setting the time
Remote control only
This is a 12-hour display clock.
This example in the figure shows how to set the time for 4:25 p.m..
1 Switch on the power.
2 Press [CLOCK/TIMER] to select
“CLOCK”.
Every time you press the button:
CLOCK RECPLAY
3 (within 7 seconds or so)
Press [g/REW/4] or [3/FF/f] to
set the present time.
4 Press [CLOCK/TIMER] to finish setting
the time.
The display will return to whatever was displayed before you
set the time.
To display the time when system is ON
Press [CLOCK/TIMER] to select “CLOCK”.
To display the time when system is OFF
Press [CLOCK/TIMER].
The time will be displayed for about 5 seconds and then the display
will return to whatever was previously displayed.
Note
The clock may lose or gain some time over a period. Readjust if
necessary.
Previous display
B