Filter
Top Products
7
RQT7912
The Radio
Preparation:
≥ When using batteries, press [].
≥ Press [TUNER BAND] to select “FM” or “AM”.
Manual tuning
[1]
Press [REW/–/
6
] or [
5
/+/FF] to select a station.
To tune automatically
Press and hold [REW/–/6] or [5/+/FF] until the
frequency starts changing rapidly.
≥ Auto tuning may be interrupted when there is excessive
interference.
≥ To cancel auto tuning, press [REW/–/6] or
[5/+/FF] once again.
[2] Press [+, – VOLUME] to adjust volume.
To use auto scan
You can search for a station by listening to all tuned-in stations
for 8 seconds each.
[1] Press [AUTO SCAN].
[2] Press [AUTO SCAN] when you find the desired
station.
Auto scan ends when it reaches the original frequency again.
To stop during the process, press [AUTO SCAN].
To improve FM sound quality
Press [PLAY MODE] to display “ ”.
Monaural sound is selected and noise reduces when reception
is weak.
Press [PLAY MODE] again to cancel the mode.
≥ To improve reception
FM : Change the length and direction of the antenna.
AM : Change the direction of the unit.
≥
AM reception is briefly interrupted if [< DECK] is pressed.
≥ To improve reception when using the unit in a building or
vehicle, place it near a window.
Preset tuning
Up to 16 stations can be set in the FM and AM band.
[1] Press [REW/–/6] or [5/+/ FF] to tune to the
required station.
[2] Press [ MEMORY CLEAR].
[3] While “ ” is flashing
Turn [TIME/PRESET TUNE TRACK SKIP ] to select
the channel and press [ MEMORY CLEAR] or on
remote control, press the numeric buttons to select
channels.
≥ For channels 1 to 9, press the corresponding number.
≥ For channels 10 to 16, press [S10], then the two digits.
If “ ” goes off during presetting, return to step [1].
To select channels
Turn [TIME/PRESET TUNE TRACK SKIP ] to
select the channel or on remote control, press the
numeric buttons to select channels.
To use preset scan
You can search for a station by listening to all preset channels
for 8 seconds each.
[1] Press and hold [C/: ALBUM] or [ALBUM 9/
D] until “PS” appears on the display.
[2] Press [C
/: ALBUM] or [ALBUM 9/D] when
you find the desired channel.
Preset scan ends after searching through each preset channel
once. To stop during the process, press
[C/: ALBUM] or
[ALBUM 9/D].
To skip the preset channel,
1 Select the desired station.
2 Press [MEMORY CLEAR].
3 While “ ” is flashing
Turn [TIME/PRESET TUNE TRACK SKIP ] to display
“– –”.
4 Press [ MEMORY CLEAR].
To select the skipped channel,
Press the numeric buttons.
V
OLUME
REW
AMFM
E_EB_GN_RQT7912-B.book 7 ページ ２００４年１２月８日 水曜日 午後４時１５分