Panasonic RQTV0097-2P Speaker System User Manual


 
RQTV0097
15
ENGLISHEnglishEnglish
Specifi cations
AMPLIFIER SECTION
FTC OUTPUT POWER both channel driven
simultaneously
10% Total harmonic distortion
60
Hz to 3
kHz
(Low channel)
SC-PM53
40
W per channel (6
Ω)
SC-PM533
38
W per channel (6
Ω)
3
kHz to 16
kHz
(High channel)
SC-PM53
39
W per channel (6
Ω)
SC-PM533
36
W per channel (6
Ω)
Total Bi-Amp power
SC-PM53
79
W per channel
SC-PM533
74
W per channel
RMS OUTPUT POWER both channel driven
simultaneously
10% total harmonic distortion
1
kHz
(Low channel)
SC-PM53
45
W per channel (6
Ω)
SC-PM533
43
W per channel (6
Ω)
8
kHz
(High channel)
SC-PM53
45
W per channel (6
Ω)
SC-PM533
42
W per channel (6
Ω)
Total Bi-Amp power
SC-PM53
90
W per channel
SC-PM533
85
W per channel
Input Impedance
Music port 250 mV 12 kΩ
Output Impedance
Headphone 16
Ω to 32
Ω
Phone jack
Terminal Stereo, 3.5 mm (
1
/
8
")
Music port input jack
Terminal Stereo, 3.5 mm (
1
/
8
")
FM TUNER SECTION
Frequency range
87.9
MHz to 107.9
MHz (200
kHz steps)
87.5
MHz to 108.0
MHz (100
kHz steps)
Sensitivity 0.3
µV (IHF)
S/N 26
dB 0.2
µV
Antenna terminals 75
Ω (unbalanced)
Preset station FM 15 stations
AM 15 stations
AM TUNER SECTION
Frequency range 520 kHz to 1710
kHz (10
kHz steps)
Sensitivity
S/N 20
dB (at 1000
kHz) 900
µV/m
CASSETTE DECK SECTION
Track system 4-track, 2-channel
Heads
Record/playback Solid permalloy head
Erasure Double gap ferrite head
Motor DC servo motor
Recording system AC bias 100
kHz
Erase system AC erase 100
kHz
Tape speed 4.8
cm/s (1
7
/
8
ips)
Overall frequency response (+3, –6
dB at DECK OUT)
NORMAL 35
Hz to 14
kHz
S/N RATIO 54
dB (A weighted)
Wow and fl utter 0.08% (WRMS)
Fast-forward and rewind time
Approx. 120 seconds with C-60 cassette tape
CD SECTION
Disc played [8 cm (3") or 12 cm (5")]
(1) CD-Audio (CD-DA)
(2) CD-R/RW (CD-DA, MP3, WMA formatted disc)
(3) MP3/WMA
Sampling frequency
CD-DA 44.1
kHz
MP3/WMA 32
kHz, 44.1
kHz, 48
kHz
Bit rate
MP3/WMA 32
kbps to 384
kbps
Decoding 16/20/24 bit linear
Pick up
Wavelength 785 nm
Beam source Semiconductor laser
Laser power CLASS 1
Audio output (Disc)
Number of channels 2-Channel
Frequency response 20
Hz to 20
kHz
(+1dB, -2
dB)
Wow and fl utter Below measurable limit
Digital fi lter 8
fs
D/A converter MASH (1 bit DAC)
SPEAKER SECTION
Type 2 way, 2 speaker system
Speaker(s)
Woofer 10cm (4˝) cone type (6
Ω)
Tweeter 6
cm (2
3
/
8
˝) cone type (6
Ω)
Impedance 6
Ω
Input power (IEC)
HIGH 90
W (Max)
LOW 90
W (Max)
Output sound pressure 80
dB/W (1.0 m)
Crossover over frequency 2.2 kHz
Frequency range 45
Hz to 35
kHz (-16
dB)
50
Hz to 31
kHz (-10
dB)
Dimensions (W x H x D) 144
mm x 249
mm x 200
mm
(5
11
/
16
˝ x 9
13
/
16
˝ x 7
7
/
8
˝)
Mass 1.9
kg (4.2
lb.)
GENERAL
Power supply AC 120
V, 60
Hz
Power consumption 140
W
Dimensions (W x H x D) 175
mm x 249
mm x 355
mm
(6
7
/
8
˝ x 9
13
/
16
˝ x 13
63
/
64
˝)
Mass 5.4
kg (11.9
lb.)
Operating temperature range
+5°C to +35°C (+41°F to +95°F)
Operating humidity range
5% to 90% RH (no condensation)
Power consumption in standby mode 0.4
W
Note
1. Speci cations are subject to change without notice.
Mass and dimensions are approximate.
2. Total harmonic distortion is measured by the digital spectrum
analyzer.
3. The labels “HIGH” and “LOW” on the rear or the speakers refer to
High frequency and Low frequency.
Maintenance
If the surfaces are dirtyIf the surfaces are dirty
To clean this unit, wipe with a soft, dry cloth.
• Never use alcohol, paint thinner or benzine to clean this
unit.
• Before using chemically treated cloth, read the instructions
that came with the cloth carefully.
For a cleaner, crisper soundFor a cleaner, crisper sound
Clean the heads regularly to assure good quality playback
and recording.
Use a cleaning tape (not included).
When moving the unit
1
Remove all discs.
2
Press [POWER y/I] to turn the unit off.
3
Disconnect the AC power supply cord.
RQTV0097_2P_EN.indd 15RQTV0097_2P_EN.indd 15 2/6/06 3:35:15 PM2/6/06 3:35:15 PM