Filter
Top Products
RQTV0080
9
ENGLISHEnglishEnglish
Cassette tape
Disc lid
CD OPEN/CLOSE 0
Top of unit
Basic playBasic play
1
Press [0] and insert the cassette.
Insert inside the guidesForward side
2
Close the lid by hand.
3
Press [TAPE 3] to start play.
To play the other side of the cassette, turn the cassette over.
To Action
stop tape playback
Press [ 7 ].
start one-touch play Press [TAPE 3] when the unit is OFF with
the cassette loaded.
fast-forward and
rewind
Press
[ /REW/4] or [ /FF/¢] in the
stop mode.
Note
• Tapes exceeding 100 minutes are thin and can break or get caught
in the mechanism.
• Endless tapes can get caught up in the deck’s moving parts if used
incorrectly.
TPS (Tape Program Sensor)TPS (Tape Program Sensor)
This function enables you to search the beginning of a track,
up to a maximum of 9.
Press
[ /REW/4] or [
/FF/¢] during play.
Play resumes from the track found.
Note
TPS may not function properly:
• with short silent parts
• when noise occurs between tunes
• if silent parts are found within tunes
RecordingRecording
Use normal position tapes.
High position and metal position tapes can be used, but this
unit will not be able to record or erase them correctly.
Preparation
Wind the leader tape so that recording can begin
immediately.
Recording the radioRecording the radio
1
Insert the cassette to be recorded.
2
Tune to the required station (refer to page 10).
3
Press [¶ REC/
8
] to start recording.
Recording discsRecording discs
1
Insert the cassette to be recorded.
2
Push [CD OPEN/CLOSE 0] to insert the disc and
close the lid.
3
Press [CD 3/
8
] and then [7, –DEMO].
4
Press [PLAY MODE] to select your desired mode
(refer to page 7).
5
Press [¶ REC/
8
] to start recording.
Recording programmed tracksRecording programmed tracks
1
Insert the cassette to be recorded.
2
Program the tracks you want (refer to page 8).
3
Press [¶ REC/
8
] to start recording.
Other basic operationsOther basic operations
To Action
erase a recorded
sound
1) Insert the cassette to be recorded.
2)
Press [TAPE 3] and then [7, –DEMO].
3) Press [¶ REC/8].
stop recording
Press [ 7 ].
stop recording
temporarily
1) Press [¶ REC/
8].
2) Press again to resume recording.
record on the other
side of the tape
Turn the cassette over and press
[¶ REC/
8].
Erasure preventionErasure prevention
The illustration shows how to remove the tabs to prevent
recording. To record on the tape again, cover as shown.
Side A
Tab for side A
Tab for side B
To re-record
Normal tape
Adhesive tape
PM23_P_En_Sp.indd 9PM23_P_En_Sp.indd 9 1/16/06 1:47:00 PM1/16/06 1:47:00 PM