Panasonic PT-AE8000 Home Theater System User Manual


 
S P E C F I L E
PT-AE8000
Full High-Definition Home Cinema Projector
As of August 2012
SFL12M016
13/13
Notes on projector placement and operation
The projector uses a high-wattage lamp that becomes very hot during operation. Please observe the
following precautions.
1. Never place objects on top of the projector while it is operating.
2. Make sure there is an unobstructed space of 100 mm (3-15/16 inches) or more around the projec-
tor’s air intake openings.
3. If the projector is placed in a box or enclosure, ensure the temperature of the air surrounding the
projector is between 0°C and 35°C (32°F and 95°F). Also make sure the projector’s intake and
exhaust openings are not blocked. Take particular care to ensure that hot air from the exhaust
openings is not sucked into the intake openings.
100 mm (3-15/16 in)
or more
100 mm (3-15/16 in)
or more
100 mm (3-15/16 in)
or more
Direction of air intake and exhaust
Intake
Exhaust
Operating the projector continuously
1. If the projector is to be operated continuously 6 hours or more, lamp replacement cycle duration
becomes shorter.
2. The lamp replacement cycle duration becomes shorter if the projector is operated repeatedly for short
periods.
Weights and dimensions shown are approximate. Specifications and appearance are subject to change without notice.
Product availability differs depending on region and country. This product may be subject to export control regulations.
All other trademarks are the property of their respective trademark owners.
Command example
To set the input to HDMI 1, send the command as
shown below.
STX
Start Command Parameter End
IIS : HD1 ETX
NOTE: When sending commands without parameters, a colon (:) is not necessary.