Filter
Top Products
13
RQTV0105
POWER
INPUT SELECTOR
TUNE
MENU
RETURN
SETUP
MUSIC PORT
VOLUME
ENTER
SURR
OUND
MUSIC
TUNED
MONO
SLEEP
PCM
ST
ft
kHz
MHz
DIGITAL INPUT
DIGITAL DTS
PL 2CH MIX
SFC
M
W
C.FOCUS
Main unit
[% DIGITAL, DTS, % PL ΙΙ]
Lights to indicate the source's input
signal and decoding format used.
% DIGITAL: Dolby Digital sources
DTS: DTS sources
% PL ΙΙ: Dolby Pro LogicΙΙ
decoder is being used
Display
[SFC, 2CH MIX]
SFC: Appears when
you are using an SFC
mode
2CH MIX: Appears
when you are
listening to a multi-
channel source with
headphones
[INPUT SELECTOR, <, >]
For selecting input.
Control guide/Making a recording/
The RESET function
[VOLUME]
Volume control.
[ ]
Headphone jack
Plug type: 3.5 mm (
1
/
8
") stereo
Sound does not come from the speakers if
you connect headphones.
Avoid listening for prolonged periods of time
to prevent hearing damage.
•
•
POWER
INPUT SELECTOR
TUNE
MENU
RETURN
SETUP
MUSIC PORT
VOLUME
ENTER
SURROUND
MUSIC
INPUT SELECTOR
Making a recording
You can record to a unit connected to DVR/DVD-P OUT.
You can record any analog source except DVR/DVD-P IN.
1. Press [INPUT SELECTOR < or >] to select the
source to be recorded.
2. Begin recording.
Follow your recording unit's operating instructions.
3. Start the source to be recorded.
This unit cannot record digital sources. Connect through the
analog terminals and select "ANALOG" input (➡ page 18).
Note
Manufactured under license from Dolby Laboratories.
“Dolby”, “Pro Logic” and the double-D symbol are trademarks
of Dolby Laboratories.
“DTS” and “DTS Digital Surround” are registered trademarks
of Digital Theater Systems, Inc.
[PCM, C. FOCUS]
PCM: Lights when the PCM FIX
mode is set
C.FOCUS: Appears when you
are using Center Focus
[DIGITAL INPUT]
Lights when input is
digital.
POWER
INPUT SELECTOR
TUNE
MENU
RETURN
SETUP
MUSIC PORT
VOLUME
ENTER
SURROUND
MUSIC
TUNE
MENU
RETURN
SETUP
ENTER
The RESET function
The operation settings for the unit will be initialized to the
settings made at the time of shipment.
However, any preset radio stations will not be erased.
1. Press and hold [
―
SETUP] to enter the setup
menu.
2. Press [TUNE - or +] to select "RESET"
➡ [ENTER].
3. Press [TUNE +] to select "RESET YES"
➡ [ENTER].
To cancel, select "RESET NO".
SC-HT40PP.indb 13 1/20/2006 5:27:25 PM