Filter
Top Products
Simple setup
RQT6387
10
AC IN
1
3
1
2
Adhesive tape
FM indoor antenna
Fix the other end of the antenna
where reception is best.
AM loop antenna
Stand the antenna up on its base.
Keep loose antenna cord away from other wires and cords.
To household
mains socket
AC mains lead (included)
Insertion of connector
Even when the connector is perfectly
inserted, depending on the type of inlet
used, the front part of the connector
may jut out as shown in the drawing.
However there is no problem using the unit.
Conserving power
The unit consumes power (approx. 0.7 W) even when it is turned off
with [Í]. To save power when the unit is not to be used for a long time,
unplug it from the household mains socket. Remember to reset the ra-
dio stations and any other memory items before using the unit again.
For your reference
Information you enter into the unit’s memory remains intact for up to
a week after the AC mains lead is disconnected.
[For\the\United\Kingdom\only]
BE SURE TO READ THE CAUTION FOR THE AC MAINS
LEAD ON PAGE 4 BEFORE CONNECTION.
Television and flat cable [DT300] ]DT100]
STEP3
Connect directly to your television.
Do not connect the unit through a video cassette recorder, because the picture may not be played correctly due to the copy guard.
Antennas and AC mains lead [DT300] ]DT100]
STEP4
S-VIDEO OUT terminal
The S-video terminal achieves a more vivid picture than the VIDEO
OUT terminal by separating the chrominance (C) and luminance(Y)
signals. (Actual results depend on the television.)
Appliance inlet
Connector
Approx. 6 mm
[For\the\United\Kingdom,\Continental\Eupope\and\Russia]
Use the RCAJ adaptor (included) if your television
has a 21-pin SCART terminal. You do not have to
connect anything to the AUDIO terminals.
VIDEO
O
UT
Video terminal
Video cable
(included)
To your
television
Audio terminals
RCAJ adaptor
VIDEO
OUT
S-VIDEO
OUT
1
1
2
VIDEO
IN
To connect
cable
To unplug
cable
Noise filter
≥Leave the noise filter attached.
Simple setup
Video
cable
(included)