Filter
Top Products
4
Connecting to Power
Plug the supplied AC adapter’s small
straight barrel plug into the transmit-
ter’s
DC 18V
jack. Then plug the
adapter into a standard AC outlet.
Cautions:
• The transmitter’s supplied AC
adapter (in a box marked
FOR
TRANSMITTER
) provides 18 volts
and at least 150 milliamps, and
its plug’s center tip is positive.
Using an adapter that does not
meet these specifications could
damage the adapter or the trans-
mitter.
•The
CHARGER
jack on the trans-
mitter is for charging the
RadioShack PRO-100 Wireless
Headphones (Cat. No. 33-1145).
Do not plug any other device into
this jack.
INSTALLING THE
SPEAKERS
Select a location for each speaker
that is near an AC outlet.
Caution:
Each speaker’s supplied
AC adapter (in a box marked
FOR
SPEAKER
) provides 15 volts and at
least 800 milliamps, and its plug’s
center tip is positive. Using an adapt-
er that does not meet these specifica-
tions could damage the adapter or
the speaker.
Follow these steps to install the
speakers.
1. Turn off both speakers by rotating
their
POWER/VOL
knobs fully
counterclockwise until they click.
2. Set each speaker’s mode switch
as follows:
L
— For the left stereo speaker
R
— For the right stereo speaker
MONO
— If your source is mono
3. Plug the AC adapter’s large right-
angle barrel plug into the
speaker’s
DC 15V
800mA
jack.
4. Plug the AC adapter into a stan-
dard AC outlet.
40-1372.fm Page 4 Tuesday, August 10, 1999 3:25 PM