Filter
Top Products
60 (E)
CONTENTS
Video output signals and servo reference signal
This section explains how the output signals and
servo reference signal are selected.
External synchronization of video
output signals
The video output signals are output in synchronization
with the REF VIDEO input signal or video input signal.
As shown in the figure below, this signal is selected in
accordance with the setup menu settings, VTR mode
and availability of the video input signal.
<Notes>
Synchronization is determined as follows depending
on the availability of the REF VIDEO input signal
when “BB”, “CB100” or “CB75” has been selected as
the setup menu No. 600 (INT SG) setting.
OWhen the REF VIDEO input signal is available:
Synchronization with the REF VIDEO input signal
OWhen the REF VIDEO input signal is not available:
Internal synchronization
Start
What is the
setup menu No. 304 (SERVO
REF) setting?
EXT
Is the unit
in one of the editing
modes?
YES
Has the unit
been set to the recording
mode?
YES
AUTO
What is the
setup menu No. 601 (OUT
VSYNC) setting?
Is the
video input signal available?
N-VF
YES
VF
NO
NO
Is the
REF VIDEO input signal
available?
Internal synchronization
Synchronization with the
REF VIDEO input signal
Synchronization with
the video input signal
YES
NO
Is the
REF VIDEO input signal
available?
NO
NO
NON-STD
Is the
video input signal a composite
signal?
YES
NO
What is
the setup menu No. 303
(STD/NON-STD)
setting?
AUTO
NON-STD
Is the
video input signal a standard
or non-standard signal?
STD
STD
YES