Filter
Top Products
6 © 2008 directed electronics—all rights reserved
High-Pass Crossover
When the switch is to the left (FULL position), the high-pass crossover is bypassed. When the
switch is to the right (HPF position), the high-pass crossover is active. The high-pass crossover is
continuously variable from 50Hz to 500Hz.
AMPLIFIER WIRING
Power Connections for the Orion Cobalt CO6004
● Orion Cobalt CO6004 Fuse Size: 2 x 25 AMP ATC
● Power connections accept up to 4 AWG wire.
● 4 AWG power and ground wire recommended for optimal performance.
● Connect 12V+ to the battery through fuse holder. This connection provides +12V main
power to the amplifier.
● Power wire must be fused no more than 18" from battery.
● Ground amplifier to a good chassis ground as close as possible to the amplifier.
● Connect REM terminal to remote turn-on lead from source unit. This connection pro-
vides +12V power to turn-on the amplifier.
● Add extra ground wire between the negative terminal of the battery and the chassis.
Speaker Wiring Diagram CO6004
The Orion Cobalt CO6004 amplifier offers two sets (front and rear) of two positive and two negative
output terminals for ease of connecting the speakers to the amplifier. Each amplifier is stable to 2Ω
per channel or 4 ohm per bridged channel pair.
--++--++
2 channels
Bridged Front & Rear
bridged
bridged
4Ω or 8Ω 4Ω or 8Ω
--++--++
4 channel
2Ω or 4Ω
2Ω or 4Ω 2Ω or 4Ω
2Ω or 4Ω
Figure 3
Figura 3
Abbildung 3