Filter
Top Products
17
There is too much noise. • Poor-quality tape is being used. • Use a better-quality tape.
• There is a faulty connection. • Check all connections.
• Recording level is too low. • Turn up
REC LEVEL
and re-record.
• The tape heads are dirty. • Clean the tape heads.
ASMS does not operate properly. • Blanks between selections are less than 4 sec-
onds long.
• Use tapes with blanks of 4 seconds or more
between selections.
The system remote control does
not work.
• The control cord is not connected.
• The audio cables are not connected.
• Properly connect the control cord.
• Properly connect the audio cables.
CD-deck synchro recording does
not work.
• The CD-deck synchro control cord is not con-
nected.
• Properly connect the control cord.
• The cassette tape’s erase protection tabs are
broken.
• Replace the cassette with one with unbroken
tabs or cover the holes with tape.
The
CD-DECK SYNCHRO
stops
working during CD-Deck Syn-
chro recording.
• The end of the tape was reached during CD-
Deck Synchro recording.
• Replace the tape with a longer one.
• After the deck entered the standby mode, more
than 1 minute elapsed before the CD player
resumed play.
• Change the disc and press
CD SYNCHRO
RECORD
again.
Symptom Cause Remedy