Filter
Top Products
8
• Always connect the adapter to the SCP-90’s
DC
3V
jack before you connect it to the AC outlet.
Then disconnect the adapter from the AC outlet
before disconnecting it from the SCP-90.
Follow these steps to power the SCP-90 from a stan-
dard AC outlet.
1. Set the adapter’s voltage switch to 3V.
2. Put the adapter’s
3.4 mm outer diam-
eter/1.3 mm inner
diameter barrel
plug onto the
adapter’s cord so it
reads –TIP.
3. Pull out the attached rubber plug from the SCP-
90’s
DC 3V
jack.
4. Insert the adapter’s
barrel plug into the
SCP-90’s
DC 3V
jack.
Add
Illust.
Illust.
14-1233.fm Page 8 Friday, July 2, 1999 10:46 AM