Filter
Top Products
En-21
You can name presets for easy identification. The pre-
set name may contain of up to ten characters.
Erasing Presets
1. Select the preset you want to erase.
2. Press the [SETUP] button, and then use
Up/Down Arrow [ ]/[ ] buttons to
select “Preset Erase”.
3. Press [ENTER].
A message requesting confirmation appears.
To cancel the Preset Erase function at this point,
press the [RETURN] button.
4. To erase the preset, press [ENTER].
The preset is erased and “Erase OK?” appears on the
display.
5. Press [ENTER].
The preset is erased and “Complete” appears on the
display.
Naming Presets
1. Select the preset you want to name.
2. Press the [SETUP] button, and then use
the Up/Down Arrow [ ]/[ ] buttons to
select “Name Edit”
3. Press [ENTER].
4. Use the Up/Down [ ]/[ ] buttons to
select the available characters (see next
page), and use the Left/Right [ ]/[ ] but-
tons to move the cursor.
5. When you’ve finished entering the name,
press [ENTER].
“Name Edit” appears on the display.
6. Press the [RETURN] button to return to
the normal display.