Filter
Top Products
TV
VIDEO 1
IN
Cable/
satellite
VIDEO
OUT
AUDIO
OUT
L
R
Antenna input
(e.g..RF IN)
DVD/BD
player
VIDEO
OUT
AUDIO
OUT
DIGITAL
OUT
COAXIAL
L
R
COAXIAL
DIGITAL
OUT
TV
HDMI
IN
HDMI
OUT
Antenna input
(e.g., RF IN)
Cable/satellite
HDMI
OUT
DVD/BD player
AV Component Hookup
IF NO HDMI
See the other side of this sheet for the Speaker hookup.
If your TV or player doesn’t support HDMI, use the analog or digital
connections shown below.
Please ensure the monitor input
(VIDEO 1, VIDEO 2, VIDEO 3, etc.)
selected corresponds to actual
connection used.
Coaxial feed from
TV antenna
If you are not using
Cable/satellite box,
please refer to the
instruction manual.
Assigning the Digital Input
If there’s no sound, you’ll need to assign the
digital inputs as necessary using the setup
menus on the AV receiver’s display.
If you connect your DVD/BD player to the AV
receiver’s DIGITAL IN COAXIAL 1, and your
cable/satellite receiver to the DIGITAL IN
COAXIAL 2, as shown, it’s not necessary to
assign the digital input.
On the front panel
Assigning the HDMI Input
If you connect a video component to an
HDMI input, you must assign that HDMI
Input to an input selector in Setup.
If you make the same connections as shown
here, you must assign the “DVD/BD” setting
to “HDMI 1”, and assign the “CBL/SAT”
setting to “HDMI 3”.
On the front panel
With an HDMI cable you can send both audio and video with a single cable,
making connecting simple and keeping wires neat.
If you have an HDMI-compatible TV and players, you can connect them
to the AV receiver with HDMI cables. Digital audio signals received
at HDMI IN input are output by the speakers and headphones connected
to the AV receiver.
Coaxial feed from
TV antenna
If you are not using
Cable/satellite box,
please refer to the
instruction manual.