Filter
Top Products
40
En
Theater-Dimensional Setting
■ Listening Angle
`Wide
:
Select if the listening angle is 40 degrees.
`Narrow:
Select if the listening angle is 20 degrees.
With this setting, you can optimize the Theater-Dimen-
sional listening mode by specifying the angle of the
front left and right speakers relative to the listening
position. Ideally, the front left and right speakers should
be equidistant from the listening position and at an
angle close to one of the two available settings.
Menu Name Edit
You can enter a preset name for each individual input
selector for easy identification. When entered, the preset
name will appear on the display.
■ Name
`---, Blu-ray, DVD, HD DVD, VCR, DVR, Tivo,
CableSTB, SAT STB, PS3, Wii, Xbox, PC, TV, CD,
TAPE, iPod:
To reset to the default, select “---”.
Note
• Can not set the input selector by the same name.
• This menu cannot be used for the TUNER input selector.
Menu Hardware
Speaker Settings
If the impedance of any speaker is 4 ohms or more but less
than 6, set the minimum speaker impedance to 4 ohms.
If you bi-amp the front speakers, you must change the
“Speakers Type” setting.
For hookup information, see “Bi-amping the Front Speak-
ers” (➔ 13).
Note
• When bi-amping is used, the AV receiver is able to drive up to
5.1 speakers in the main room.
• Before you change these settings, turn down the volume.
■ Sp Impedance
`4ohms:
Select if the impedance of any speaker is 4 ohms or
more but less than 6.
`6ohms
:
Select if the impedances of all speakers are between
6 and 16 ohms.
Note
• (North American models) Do not support speakers with an
impedance of less than 6 ohms.
■ Speakers Type
`Normal
:
Select this if you’ve connected your front speakers
normally.
`Bi-AMP:
Select this if you’ve bi-amped your front speakers.
■ Front High/Zone2
`Front High
:
Front high speakers can be used.
`Zone2:
Zone2 speakers can be used.
Select “Zone2” if you’ve connected your Zone 2 speakers
to FRONT HIGH OR ZONE 2 SPEAKERS L/R termi-
nals (➔ 46).
Note
•If the “Speakers Type” setting is set to “Bi-AMP”, this setting
cannot be selected.
■ SurrBk/FrontHigh
`Front High:
Front high speakers can be used.
`SurrBack
:
Surround back speakers can be used.
Select “Front High” if you’ve connected your Zone 2
speakers to FRONT HIGH OR ZONE 2 SPEAKERS L/
R terminals, and the front high speakers to SURR BACK
OR FRONT HIGH SPEAKERS L/R terminals.
Note
•If the “Front High/Zone2” setting is set to “Front High”, this
setting is set to “SurrBack”.
•If the “Speakers Type” setting is set to “Bi-AMP”, this setting
cannot be selected.
Name Edit
Preparation
Press the input selector buttons to select an input source.
Hardware
If you change these settings, you must run
Audyssey 2EQ
®
Room Correction and Speaker
Setup again (➔ 23).
20°/40°
Front left speaker Front right speaker