Filter
Top Products
82
En
The AV receiver’s remote controller can learn the com-
mands of other remote controllers. By transmitting, for
example, the Play command from your CD player’s
remote controller, the remote controller can learn it, and
then transmit the exact same command when its is
pressed in the CD remote mode.
This is useful when you’ve entered the appropriate remote
control code (➔ 79) but some buttons don’t work as
expected.
Note
• The following buttons cannot learn new commands: REMOTE
MODE, ALL OFF, MY MOVIE, MY TV, MY MUSIC.
• The remote controller can learn approximately 70 to 90 com-
mands, although this will be less if commands that use a lot of
memory are learned.
• Remote controller buttons such as Play, Stop, Pause, and so on
are preprogrammed with commands for controlling Onkyo CD
players, cassette decks, and DVD players. However, they can
learn new commands, and you can restore the preprogrammed
commands at any time by resetting the remote controller (➔ 80).
• To overwrite a previously learned command, repeat this proce-
dure.
• Depending on the remote controller that you are using, there may
be some buttons that won’t work as expected, or even some
remotes that cannot be learned at all.
• Only commands from infrared remote controllers can be learned.
• When the remote controller’s batteries expire, all learned com-
mands will be lost and will have to be learned all over again, so
don’t discard your other remote controllers.
■ Deleting Learning Commands
1. While holding down REMOTE MODE for the mode
in which you want to delete the command, press and
hold down TV until REMOTE MODE button
lights (about 3 seconds).
2. Press REMOTE MODE or the button from which you
want to delete the commands.
REMOTE MODE button flashes twice.
When you press REMOTE MODE, all commands
learned in that remote mode will be deleted.
You can program the remote controller’s ACTIVITIES to
perform a sequence of remote control actions.
Example:
To play a CD you typically need to perform the following
actions:
1. Press RECEIVER to select the Receiver remote con-
troller mode.
2. Press ON to turn on the AV receiver.
3. Press TV/CD to select the TV/CD input source.
4. Press to start playback on the CD player.
You can program ACTIVITIES so that all four actions are
performed with just one button press.
Learning Commands
1
While holding down REMOTE MODE for the
mode in which you want to use the command,
press and hold down ON until REMOTE MODE
button lights (about 3 seconds).
2
On the supplied remote controller, press the but-
ton you want to learn the new command.
3
Point the remote controllers at each other, about 2
to 6 inches (5 to 15 cm) apart, and then press and
hold the button whose command you want to learn
until REMOTE MODE button flashes.
If the command is learned successfully, REMOTE
MODE button flashes twice.
4
To learn more commands, repeat steps 2 and 3.
Press any REMOTE MODE when you’ve finished.
REMOTE MODE button flashes twice.
ON
REMOTE
MODE
POWER
SLEEP
DIMMER
SUR
MODE
VIDEO-1
VIDEO-2
TAP E
DVD
C D
C D
DVD
TU
NER
TUNER
PHONO
INPUT SELECT
OR
DISC
VOLUME
CH SEL
PRESET
UTI
NG
TEST
TON
E
MULTI-CH
INPUT
GROUP
About 2 to 6
inches (5 to 15 cm)
Supplied remote
controller
Using Normal Macros