Filter
Top Products
Advanced Settings (Setup Menu)
En-33
Setting Item Default Value Setting Details
Powered Zone 2 No Set the connection of speakers to Zone 2 speaker
terminals.
"Yes": When speakers are connected to ZONE2
speaker terminals
"No": When speakers are not connected to ZONE2
speaker terminals
● This item will be set to "No" when "Bi-Amp" is set
to "Yes".
Speaker
Impedance
(European,
Australian and
Asian models)
6ohms Set the impedance of the connected speakers.
"4ohms": When any of the connected speakers have
"6ohms": When the connected speakers all have
● For impedance, check the indications on the back
of the speakers or their instruction manual.
Crossover
Allows you to change speaker configurations, such as crossover frequency. Settings are
automatically configured if you use the Automatic Speaker Setup. Audio will not be output
while you are making this setting.
Setting Item Default Value Setting Details
Front 100 Hz Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
● If "Configuration" - "Subwoofer" is set to "No",
"Front" will be fixed to "Full Band" and the low
pitched range of the other channels will be output
from the front speakers. Refer to the instruction
manual of your speakers to make the setting.
Center 100 Hz Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
● "Full Band" can be selected only when "Front" is
set to "Full Band".
● If an item cannot be selected even though
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels.
Setting Item Default Value Setting Details
Height 100 Hz Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
● "Full Band" can be selected only when "Front" is
set to "Full Band".
● If an item cannot be selected even though
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels.
Surround 100 Hz
Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
● "Full Band" can be selected only when "Front" is
set to "Full Band".
● If an item cannot be selected even though
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels.
Back 100 Hz Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
● This cannot be selected in the following
conditions.
– The setting for "Configuration" - "Bi-Amp" is
"Yes"
– "Configuration" - "Powered Zone 2" is set to
"Yes" and ZONE 2 is on
● "Full Band" can be selected only when
"Surround" is set to "Full Band".
● If an item cannot be selected even though
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels.
LPF of LFE 120Hz Set the low-pass filter for LFE (low-frequency effect)
signals in order to pass lower frequency signals than
the set value and thus cancel unwanted noises. The
low-pass filter will be effective only on sources with
LFE channel.
The value from "80Hz" to "120Hz" can be set.
"Off": Do not use this function