Filter
Top Products
Advanced Operations
En-48
Note
*1
• The video preview is not displayed when:
– HDMI IN 5/6/7 is the current HDMI input source, or
– No signal is present on the current input source.
*2
“Dynamic EQ” and “Dynamic Volume” cannot be selected
when any of the THX listening modes is selected, with
“Loudness Plus” set to “On” or “Preserve THX Settings” set
to “Yes” (➔ page 56).
*3
When the “Monitor Out” setting is set to “Sub”, “Video”
cannot be selected (➔ page 52).
*4
Only when you have selected “Custom” in the “Picture
Mode” (➔ page 61), pressing ENTER allows you to adjust
the following items via the Quick Setup: “Brightness”,
“Contrast”, “Hue” and “Saturation”. Press RETURN to
return to the “Picture Mode” setting.
*5
Depending on the input source and listening mode, not all
channels shown here output the sound.
*6
• This setting is not available in either of the following cases:
–The “Audio TV Out” setting is set to “On” (➔ page 66).
–“HDMI Control(RIHD)” is set to “On” (➔ page 65) and
you’re listening through your TV speakers.
You can change various audio settings from the Quick
Setup (➔ page 47).
Note
• These settings are not available in either of the following cases:
–The “Audio TV Out” setting is set to “On” (➔ page 66).
–“HDMI Control(RIHD)” is set to “On” (➔ page 65) and
you’re listening through your TV speakers.
Tone Control
■ Bass
`–10dB to 0dB
to +10dB in 2 dB steps
You can boost or cut low-frequency sounds output
from the front speakers.
■ Treble
`–10dB to 0dB
to +10dB in 2 dB steps
You can boost or cut high-frequency sounds output
from the front speakers.
You can adjust the bass and treble for the front speakers,
except when the Direct, Pure Audio (European,
Australian and Asian models) or THX listening mode is
selected.
Operating on the AV receiver
Speaker Levels
■ Subwoofer Level
`–15dB to 0dB
to +12dB in 1 dB steps
■ Center Level
`–12dB to 0dB to +12dB in 1 dB steps
You can adjust the volume of each speaker while listening
to an input source.
These temporary adjustments are cancelled when the AV
receiver is set to standby. To save the setting you made
here, go to “Level Calibration” (➔ page 55) before
setting the AV receiver to standby.
Note
• You cannot use these function while the AV receiver is muted.
• These settings cannot be used while a pair of headphones is
connected.
• Speakers that are set to “No” or “None” in
“Speaker Configuration” (➔ page 54) cannot be adjusted.
Using the Audio Settings of Quick
Setup
1
Press TONE repeatedly to select either “Bass” or
“Treble”.
2
Use – and + to adjust.