Filter
Top Products
11
En
Connections
Connecting the AV Receiver
Connecting the Speaker Cables
The following illustration shows which speaker should be connected to each pair of terminals. If you’re using only one
surround back speaker, connect it to the SURROUND BACK or FRONT HIGH L terminals.
Tip
• You can specify whether surround back or front high speakers are connected in the “Speaker Configuration” menu (➔ page 43) or
during Audyssey 2EQ
®
Room Correction and Speaker Setup (➔ page 29).
■ Screw-type speaker terminals
Strip 12 to 15 mm of insulation from the ends of the
speaker cables, and twist the bare wires tightly, as
shown.
■ Push-type speaker terminals
Strip 10 to 12 mm of insulation from the ends of the speaker cables,
and twist the bare wires tightly, as shown.
Connecting Your Speakers
Surround back/
Front high
right
Surround
left
Surround
right
Center
Front leftFront right
Surround back/
Front high
left
12 to 15 mm
10 to 12 mm