Filter
Top Products
87
Using the Listening Modes—Continued
5.1 channel Sources (3/3)
✔: Available Listening Modes
Notes:
*1 For 7ch output, output can be switched between Front high or Front wide speakers by pressing the [SP LAYOUT] button (depending on the
“Speaker Configuration” setting (see page 95)).
*2 For 9ch output, output can be switched between the combination of Surround back and Front high, or Surround back and Front wide
speakers by pressing the [SP LAYOUT] button.
*3 AV receiver can input the DSD signal from HDMI IN. Setting the output setting on the player side to PCM might obtain a better sound
according to the player. In that case, set the output setting on the player side to PCM.
*4 • This listening mode can be selected only when all the following conditions are satisfied:
a. Center speaker is connected to the AV receiver.
b. Either of Front High speakers or Front Wide speakers is connected to the AV receiver.
• Output can be switched between Front high or Front wide speakers by pressing the [SP LAYOUT] button (depending on the “Speaker
Configuration” setting (see page 95)).
*5 This listening mode is not available while you are using Zone 2 (“Not Available” will appear on the display). If you turn Zone 2 on during
the Pure Audio listening mode, the listening mode will change to Direct.
*6 Depending on the input source, DTS is used.
• Available sampling rate for PCM input signal is 32/44.1/48/88.2/96/176.4/192kHz.
• The listening modes cannot be selected with some source formats.
Listening Mode Button
Speaker layout
T-D (Theater-
Dimensional)
✔✔✔✔
DTS Surround
Sensation
✔✔✔✔
LH RH
SBRSBL
FL FR
LW RW
C
SL SR
SW SW
LH RH
SBRSBL
FL FR
LW RW
C
SL SR
SW SW
LH RH
SBRSBL
FL FR
LW RW
C
SL SR
SW SW
LH RH
SBRSBL
FL FR
LW RW
C
SL SR
SW
*1 *1
*2*2
*1 *1 *2*2
*2 *2
SW