Filter
Top Products
34
First Time Setup
—Continued
If the impedance of any of the connected speakers is 4
ohms or more but less than 6, set the minimum speaker
impedance to “4 ohms.”
Note:
Before you change this setting, turn down the volume.
Note:
• This procedure can also be performed on the AV
receiver by using the [SETUP], [ENTER], and arrow
buttons.
This section explains how to specify your speaker con-
figuration.
For speakers with a cone diameter
larger than 6-1/2 inches (16 cm),
specify
Large
(full band)
.
For those
with a smaller diameter, specify
Small
(default crossover 100 Hz)
.
The crossover frequency can be
changed on page 55.
Minimum Speaker Impedance Setup
(not North American model)
1
Press the [RECEIVER] button, followed
by the [SETUP] button.
2
Use the Up and Down [ ]/[ ] buttons
to select “0. Hardware Setup,” and then
press [ENTER].
3
Use the Left and Right [ ]/[ ] buttons
to select the setting for “Impedance.”
4 ohms:
Select if the impedance of any con-
nected speaker is 4 ohms or more but
less than 6.
6 ohms:
Select if the impedances of all con-
nected speakers are between 6 and
16 ohms.
Press the [RETURN] button to go to step 2 of
the “Speaker Configuration” (next column).
MUTING
PREVIOUS
MENU
GUIDE
TOP MENU
SP A
/
B
SETUPRETURN
PLAYLIST/CAT PLAYLIST/CAT
--
/
---
TAPE
M
D/CDR
HDD
CABLE
ON/STANDBY
DIMMER
ENT
D TUN
SLEEP
10 11 12
INPUT SELECTOR
REMOTE MODE
V
1
V
2
V
3
C
DTAPE TUNER
DVD
MULTI CH
LISTENING MODE
TV
SURROUND
STEREO
VOL
VOL
SAT
VCR
TV
DVD
RECEIVER
C
D
INPUT
+
10
0
CLR
123
456
789
ENTER
CH
DISC
ALBUM
RETURN
1
1, 9
2–8
Speaker Configuration
1
Press the [RECEIVER] button,
followed by the [SETUP] button.
2
Use the Up and Down [ ]/[ ]
buttons to select “1. SP Config,”
and then press [ENTER].
3
While the “Subwoofer” setting is
selected, use the Left and Right
[ ]/[ ] buttons to select
Yes
or
No
.
Yes:
Select if a subwoofer is con-
nected.
No:
Select if no subwoofer is con-
nected.
4
Use the Down [ ] button to
select “Front,” and then use the
Left and Right [ ]/[ ] buttons to
select
Small
or
Large
.
Small:
Select if the front speakers are
small.
Large:
Select if the front speakers are
large.
Note:
• If the Subwoofer setting in step 3 is
set to No, this setting is fixed at Large
and does not appear.
Cone diameter
RECEIVER
SETUP