Filter
Top Products
En-14
Troubleshooting
Reset button
Bottom of unit
The unit does not work.
Press Reset button which is placed
inside the Reset engraved thin hole
on the bottom of this unit using
such as a slender rod.
Unplug the Power Cord from the
wall outlet, wait 10 seconds or more, then plug it in again.
Press the INPUT button repeatedly to switch LINE IN mode (the
source indicator lit Green), and press and hold the
(Repeat)
button on the remote control during the power is ON.
The unit is suddenly powered o .
The unit has an energy saving function. The unit automatically
enters the standby mode in the following situations.
– No sound output and without any operation for more than 10
minutes in the iPod mode or Bluetooth mode.
– No signal input for more than 10 minutes in the LINE IN mode.
In such cases, turn ON the unit again and play back the audio.
The power does not come on.
Make sure the Power Cord is connected to the wall outlet rmly.
(P.8)
The buttons on the unit do not function.
Remove and reconnect the AC adapter and turn on the unit again.
(P.8)
There is no sound output.
Check if the volume of the iPod/external device connected to the
unit is set to the minimum.
Make sure the sound is not muted. (P.9)
Adjust the VOLUME +/− buttons on the remote control or unit. (P.9)
There is no audio from iPod.
Make sure the iPod is connected rmly. (P.10, 11)
iPod operation is not performed.
Make sure the iPod is connected rmly. (P.10, 11)
Restart the iPod.
The iPod cannot be charged.
Make sure the iPod is connected rmly. (P.10, 11)
Make sure the Power Cord is connected to the wall outlet rmly.
(P.8)
Bluetooth connection cannot be built.
When building a Bluetooth connection between the unit and
your device for the rst time, if the connection is fail, you need
to power o your device and power on again to clear the device
name, and build the connection again. (P.12, 13)
The Docking Tray cannot be closed.
Switch the SLIDE TO CLOSE to direction of arrow. (P.10)
The remote control does not function.
Make sure the battery is inserted correctly. (P.7)
Replace the battery in the remote control with a new one if it is
weak. (P.7)
Move closer to the unit when using the remote control. (P.7)