Filter
Top Products
15
Speaker setup
4. Select the size of the center speaker.
Pressing the PRESET/MODE ADJ
√
/
®
buttons switches
among “LARGE,” “SMALL,” and “NONE.”
Note:
If you have selected “SMALL” for the front speakers, you can
select only “SMALL” or “NONE” for the center speaker.
LARGE:
When a large speaker is used as the center speaker.
SMALL:
When a small speaker is used as the center speaker.
NONE:
A center speaker is not connected.
Select whichever appropriate and press the ENTER/SCAN or
ENTER button.
5. Select the size of the surround speakers.
Note:
If you have selected “SMALL” for the front speaker, you can
select only “SMALL” or “NONE” for the surround speakers.
LARGE:
When large speakers are used as the surround
speaker.
SMALL:
When small speakers are used as the surround
speaker.
NONE:
Surround speakers are not connected.
Select whichever appropriate and press the ENTER/SCAN or
ENTER button.
This completes the CONFIG SETUP settings.
Set the distance from the listening position to each speaker.
1. Press the buttons in the following sequence to display “DIS-
TANCE SETUP.”
2. Set the distance to the front speakers.
Pressing the ENTER/SCAN or ENTER button while “DIS-
TANCE SETUP” is displayed will cause the “FRONT” distance
parameter to appear.
Press the PRESET/MODE ADJ
√
/
®
buttons to set the closest
distance value. You can set the distance in the range of 1feet
(0.3m) – 30feet (9m) in 1feet (0.3m) steps.
Press the ENTER/SCAN or ENTER button to confirm the
value.
3. Set the distance to the center speaker.
Press the PRESET/MODE ADJ
√
/
®
buttons to set the closest
distance value.
Press the ENTER/SCAN or ENTER button to confirm the
value.
Note:
If you have selected “NONE” for the center speaker of the
CONFIG parameter, skip this note.
You cannot set a larger value than the front speaker distance.
You cannot set a smaller value than the front speaker distance
deducted by 5feet (1.5m).
4. Set the distance to the surround speakers.
Press the PRESET/MODE ADJ
√
/
®
buttons to set the closest
distance value and press the ENTER/SCAN or ENTER button.
Note:
If you have selected “NONE” for the surround speaker of the
CONFIG parameter, skip this note.
You cannot set a larger value than the front speaker distance.
You cannot set a smaller value than the front speaker distance
deducted by 15feet (4.5m).
This completes the DISTANCE settings.
Setting the DISTANCE parameters
ENTER
/
SCAN
ENTER
PRESET
/
MODE
ADJ
DOW
NUP
f
t
f
t
ENTER
/
SCAN
ENTER
PRESET
/
MODE
ADJ
DOW
NUP
f
t
f
t
SP
/
SYS
SETUP
SP
/
SYS
SETUP
ENTER
ENTER
/
SCAN
1
2
3
4
ENTER
/
SCAN
(ENTER)
ENTER
/
SCAN
ENTER
PRESET
/
MODE
ADJ
DOW
NUP
meter feet
f
t
f
t
or
or
or
or
ENTER
/
SCAN
ENTER
PRESET
/
MODE
ADJ
DOW
NUP
or
or
ENTER
/
SCAN
ENTER
PRESET
/
MODE
ADJ
DOW
NUP
4
or
5
or
or
or