Filter
Top Products
5
System connections
• Do not plug in the AC power cord until all other connections have been made.
• On each pair of input or output jacks, the lower jack (marked R) corresponds to the right channel, and the upper jack (marked L) to the
left channel. Refer to the amplifier’s instruction manual for further information on connections.
Power connections
LRLR
(REC)(PLAY)
IN
(REC) (PLAY)
OUT
L L
R R
REMOTE
CONTROL
Connecting to an amplifier
Connect the tape deck LINE IN
jacks to the TAPE REC jacks on the
rear panel of the amplifier and the
tape deck LINE OUT jacks to the
amplifier TAPE PLAY jacks.
Refer to the amplifier’s instruction
manual for further information on
connections.
Amplifier
See “Connecting Onkyo components for z
operation” on page 12.
To AC outlet
Plug the AC
power cord
into a wall
outlet.
1
2
3
STANDBY/ON
MAIN POWER
ON
OFF
STANDBY
STANDBY/ON
MAIN POWER
ON
OFF
STANDBY
STANDBY
STANDBY/ON
For North American model:
1. Plug the AC power cord into a wall
outlet.
The STANDBY indicator will light.
2. Press the STANDBY/ON button.
The STANDBY indicator will go out
and the display will light.
For non-North American model:
1. Plug the AC power cord into a wall
outlet.
2. Press the MAIN POWER switch.
The STANDBY indicator will light.
3. Press the STANDBY/ON button.
The STANDBY indicator will go out
and the display will light.
• Pressing the a or s button of either
Deck A or Deck B when the unit is in
standby status will also cause the dis-
play to light and playback will start.
• If the tape deck is plugged into the
amplifier’s AC outlet, the amplifier’s
AC power cord must be plugged into a
wall outlet and its power switched on
before the tape deck can operate.
Switching power on
non-North American modelsNorth American models
non-North American models
TA-RW255_En.book Page 5 Tuesday, April19,2005 4:36 PM