Filter
Top Products
4
Precautions
1. Warranty Claim
You can find the serial number on the rear panel of this unit. In case
of warranty claim, please report this number.
2. Power
WARNING
BEFORE PLUGGING IN THE UNIT FOR THE FIRST TIME,
READ THE FOLLOWING SECTION CAREFULLY.
The voltage of the available power supply differs according to
country or region. Be sure that the power supply voltage of the area
where this unit will be used meets the required voltage (e.g., AC
230 V, 50 Hz or AC 120 V, 60 Hz) written on the rear panel.
3. Do not touch this unit with wet hands
Do not handle this unit or power cord when your hands are wet or
damp. If water or any other liquid enters the case, take this unit to
an authorized service center for inspection.
4. Location of this unit
Place this unit in a well-ventilated location.
Take special care to provide plenty of ventilation on all sides of this
unit especially when it is placed in an audio rack. If ventilation is
blocked, this unit may overheat and malfunction.
Do not expose this unit to direct sunlight or heating units as this
unit’s internal temperature may rise and shorten the life of the
pickup.
Avoid damp and dusty places and places directly affected by vibra-
tions from the speakers. In particular, avoid placing the unit on or
above one of the speakers.
Be sure this unit is placed in a horizontal position. Never place it
on its side or on a slanted surface as it may malfunction.
Do not place near tuners or TV sets.
If placed next to a TV or tuner, it may cause reception interference
resulting in some noise in the TV or tuner output.
5. Care
From time to time you should wipe the front and rear panels and the
cabinet with a soft cloth. For heavier dirt, dampen a soft cloth in a
weak solution of mild detergent and water, wring it out dry, and
wipe off the dirt. Following this, dry immediately with a clean cloth.
Do not use rough material, thinners, alcohol or other chemical sol-
vents or cloths since these could damage the finish or remove the
panel lettering.
6. Points to remember
If this unit is brought from a cold environment to a warm one or is
in a cold room that is quickly heated, condensation may form on
the pickup, preventing proper operation. In this case, remove the
disc and leave the power ON for about one hour to remove the con-
densation.
When transporting this unit, be careful not to bump it.
Always close the disc tray when not loading or unloading discs to
protect delicate internal parts from dust.
Features
■
6-disc carousel changer
■
Up to five discs to be changed without interrupting
disc in play
■
Next Selection function allows next track or disc to be
selected without interrupting current track playing
■
Single-bit PWM (Pulse Width Modulation) D/A con-
verter minimizes low-level linearity errors, eliminating
loss of detail during quiet passages
■
Proprietary AccuPulse Quartz system with Polysorb
virtually eliminates the possibility of clock-oscillator
timing errors
■
8-times oversampling
■
Fixed analog output
■
Display visible even when disc tray is out
■
Oversized power transformer
■
6-mode repeat: Entire disc, All discs, Random tracks,
Programmed tracks, Random memory, Single track
■
3-mode time display: Elapse, Remain, and Total
Remain
■
compatible remote control
■
Disc Intro Scan function plays the first eight seconds of
each disc
■
Direct track or disc access via the remote controller
■
Optical digital output for direct connection to a DAT,
MD, or DSP receiver
Playable Discs
This CD changer can play back the following discs.
You cannot play back discs other than those listed above.
Avoid using heart-shaped or octagonal discs. Playing irregularly
shaped discs may damage the internal mechanism of the CD
changer.
Do not use discs on which adhesive from adhesive tape or a disc
label (if it is a rental disc) remains. Otherwise, you may not be
able to eject the discs or the CD changer may become inopera-
tive.
Memory Preservation
This unit does not require memory preservation batteries. A
built-in memory power back-up system preserves the contents
of memory during power failures and even when the POWER
switch is set to OFF.
The POWER switch must be set to ON in order to charge the
back-up system. The memory preservation period after the unit
has been turned off varies depending on climate and placement
of the unit. On average, memory contents are protected over a
period of a few weeks after the time the unit has been turned
off. This period is shorter when the unit is exposed to a very
humid climate.
Disc mark Contents Disc size
Maximum
playback time
Audio
CDs
Audio
12 cm 74 minutes
8 cm
(CD single)
20 minutes