Filter
Top Products
4
SKW-150X Powered subwoofer
Control positions and names
■ Rear Panel
Note:
The auto standby function operates on the existence or absence of a constant level input signal. If the auto standby
function does not operate properly, try slightly increasing (or decreasing) the subwoofer output level of the receiver.
Connection
For safety reasons, be sure to unplug the power cord of this unit and turn the power off for all other system components
before connecting or disconnecting any components.
■ Connection to receiver
• Connect the SKW-150X subwoofer to the SUBWOOFER PREOUT jack on your receiver.
■ Power cord
• Make sure that all connections other than the power cord for the system have already been made.
• Turning on the power for the system may cause a very brief current surge that might affect other devices such as a
computer, if both products are on the same circuit. Connect those devices to another AC outlet.
Adjustment
■ Output level
• Adjust the SKW-150X output level properly for your listening room and connected speakers.
• Note that you may possibly set the subwoofer at high output levels because super bass-range sound is not as audible
as sound in other ranges. To obtain well-balanced frequency characteristics, set the output level to a slightly lower
level than seems optimal (this will also prevent the input of overpowering signals).
Note:
The placement of the SKW-150X can greatly affect the sound that is produced. Under normal circumstances, placement
in the corner of the room provides the best results.
OUTPUT
LEVEL
LINE
INPUT
MIN
MAX
POWERED
SUBWOOFER
MODEL NO.
SKW
-
150
X
POWER
ON OFF
To AC outlet
2
31
RED
:
STANDBY
GREEN
:
ON
1 POWER switch and indicator
To turn on the SKW-150X, set the POWER switch to the
ON position (the indicator lights up).
To turn off the SKW-150X, set the POWER switch to the
OFF position (the indicator goes out).
Red: The unit is in standby mode
Green: The unit is in operation mode
The SKW-150X automatically turns to STANDBY mode
when no signal has been input for about 20 minutes. The
SKW-150X automatically enters operation mode when a
signal is input during STANDBY mode.
2 OUTPUT LEVEL knob
Use this knob to adjust the output level of the subwoofer.
3 LINE INPUT jack
Connect this jack to the subwoofer pre-out of the receiver.