6
System connections
Connecting other components
• Do not plug in the AC power cord until all other connections have been made.
• On each pair of input or output jacks, the jack marked R corresponds to the right channel, and the jack marked L to the left
channel. Refer to the amplifier’s instruction manual for further information on connections.
• Avoid bundling the audio connection cables with the power cord or speaker cables. Doing so may degrade sound reproduction.
• Insert the plugs and connectors securely. Remember that improper connection can result in noise, poor performance, or dam-
age to the equipment.
A Connection with the amplifier
Connect the DX-7222 to the CD jacks of your amplifier.
B Connection via the digital output terminal (DIGITAL
OUTPUT)
Connection to digital equipment, such as an MD recorder or
DAT.
Use an optical cable to connect this unit to the digital input
terminal of an MD recorder or DAT in order to make digital
recordings. The optical cable should have connectors which
fit into the digital terminals.
C Connections for remote control
When the DX-7222 is connected to an amplifier with the Onkyo
jack, pressing the CD operation button on the amplifier’s
remote controller enables you to operate the CD player.
Note:
• The upper and lower remote control jacks have the
same function.
• Remote control operation is not possible when only the
remote control cable is connected – the audio cables must
also be connected.
• An cable equipped with a 1/8" (3.5mm) diameter min-
iature two-conductor phone plug is included with the DX-
7222 and with every tuner, compact disc player or cassette
tape deck with the symbol.
D Connecting the AC power cord and turning the
power on
1. Insert the AC power cord into a wall outlet.
2. Press the POWER ON/OFF button.
The display will light.
Note:
To insert the AC power cord into an AC outlet on the rear panel of
another component, use the UNSWITCHED outlet.
1
22
3
4
REMOTE
CONTROL
R
L
DIGITAL
OUTPUT
OPTICAL 1
DIGITAL
OUTPUT
OPTICAL 2
ANALOG
OUTPUT
LR
(REC) jack
DIGITAL IN
DIGITAL IN
WARNING
RISK OF ELECTRIC SHOCK
DO NOT OPEN
RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
AVIS
120V
VOLTAGE SELECTOR
220-230V
COMPACT DISC PLAYER
MODEL NO. DX-7222
RATING:
Improper
connection
Insert
completely
To AC outlet
Connecting an Onkyo product
Amplifier without
MD player, DAT, etc.
Amplifier, Tuner amplifier
with digital inputsdigital inputs
Audio connection cable
with connectors enables you
to use the System function.
with digital inputs
Terminal protection caps are attached to the DIGITAL OUTPUT
terminals. Remove the cap for the terminal you wish to use when
connecting the DX-7222 to digital equipment. Replace the caps
if you are not using the DIGITAL OUTPUT terminals.
ONKYO
Optical fiber cable
(not included)
cable