Filter
Top Products
En-9
Getting to know Your Speaker Package—Continued
■ Front
STANDBY/ON indicator
Red: Subwoofer in standby mode
Blue: Subwoofer on
With the Auto Standby function, the SKW-770
automatically turns on when an input signal is
detected in Standby mode. When there’s no input
signal for a while, the SKW-770 automatically
enters Standby mode.
■ Rear
OUTPUT LEVEL control
This control is used to adjust the volume of the
subwoofer.
LINE INPUT
This RCA input should be connected to the
subwoofer pre out on your AV receiver with
supplied RCA cable.
Note:
The Auto Standby function turns the subwoofer on when
the input signal exceeds a certain level. If the Auto
Standby function does not work reliably, try slightly
increasing or decreasing the subwoofer output level on
your receiver.
To set the level of the subwoofer, use the OUTPUT
LEVEL control. Set it so that bass sounds are evenly
balanced with the treble sounds from the other speakers.
Because our ears are less sensitive to very low bass
sounds, there’s a temptation to set the level of the
subwoofer too high. As a rule of thumb, set the
subwoofer level to what you think is the optimal level,
and then back it off slightly.
Subwoofer (SKW-770)
STANDBY/ON indicator
SKW-770
To AC outlet
Setting the Subwoofer Level
HTP-770_EnFrEs.book Page 9 Wednesday, July 29, 2009 10:07 AM