Nuvo NV-T3 Stereo System User Manual


 
Troubleshooting
There is distortion and clear
reception cannot be obtained
even with a good antenna.
FM Stereo reception is noisy.
Stereo indicator (( ))
flickers.
Noisy reception
Crackling sounds.
Cannot tune station
using automatic tuning, no
stereo operation
Preset stations can no
longer be tuned in.
Cannot tune station using
automatic tuning.
There are continuous
crackling and hissing noises.
There are buzzing and
whining noises (especially in
the evening).
SYMPTOM CAUSE REMEDY
Noise from other electrical
equipment, ignition noise
from passing vehicles.
Insufficient antenna input.
Transmitter too far away,
antenna is not in direct line
of sight with transmitter
tower.
Multipath interference.
Station is too weak.
The tuning mode is set to
manual tuning.
The T-3 has been unplugged
for a long period of time.
No AC power at the wall
outlet for a long period of
time.
Weak signal.
These noises result from
certain atmospheric
conditions. All types of
electrical equipment cause
noise in AM reception.
A TV set is in use nearby.
Another station is interfering
with the received station.
Relocate the NV-T3 or the
TV.
Use an outdoor antenna and
a good ground wire.
Note: It is very difficult to
eliminate all noise.
Use manual tuning mode.
Reprogram the tuner.
Use manual tuning mode .
Try using a directional.
antenna.
Try different antenna
positions.
Check all antenna
connections. Try using a
directional antenna. Use
manual tuning.
Try using a directional
antenna.
The FM antenna should be
put up as high as possible.
Install a noise suppressor on
the equipment causing the
noise.
FM
AM